Inswan INS-3 User manual

Package Content:
- INS-3 USB Document Camera
- Camera Bracket- INS-3 USB
Customer Service
Email : [email protected]
Website : hp://www.inswan.com
- An-Glare Sheet
- Quick Guide
TS-82-937-90020
User Manual
INS-3
USB Document Camera

• Welcome:
Thanks for purchasing this product. Please read the instructions carefully before using this
product.
• FCC Compliance Statement (Class A):
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received; including interference that may cause undesired operation.
• Federal Communications Commission (FCC) Statement :
This Equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. Opera-
tion of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
• European Community Compliance Statement (Class A):
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
The symbol of the crossed out wheeled bin indicates this product should
not be placed in municipal waste. Instead, you need to dispose of the waste
equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment.

1
1. Do not look directly at the LED light source, which may cause retinal damage.
2. Carry the product by holding the base of the main unit in both hands. Never hold the
product by the arm or the camera head only.
3. The camera can be damaged if it hits a desk surface or
any hard object.
4. Never turn the arm in the opposite direction.
5. Be sure to keep one hand on the device base when
adjusting the arm and camera head.
Warning

2
Preparing the Document Camera
Knowing the Document Camera Parts
Auto Focus Button
Led Indicator
Lamp Button
Brightness Adjusting Button
Microphone
Camera
AF(Autofocus) mode switch
AF-S (Single)
AF-C (Continuous)
LED Lamp
Arm Screw
USB Cable
9
10
4
1
32
5
7
9
10

3
Setting Up
This section provides useful tips on how to adjust the document camera smoothly for your
needs.
Working Area
Minimum height 10cm
Height 31cm
for Max. working
(25.7cmx 36.4cm)
25.7cm
36.4cm

4
Mount the document
camera to the holder.
Use the groove on the
side of the arm to hold
the USB cable.
Note : Use two coins to tighten the
screws if the arm is loose.
Setting Up
Using the Camera Holder Bracket

5
Illumination Lamp
If you are in a dark environment, please
turn the LED lamp on to make better
exposure.
Anti-glare
Anti-glare sheet is a transparent
plastic that is overlaid on top of
shiny object or glossy surface to
reduce the glare.
To use, simply place the
anti-glare sheet on top of shiny
object to glossy surface such
as magazine to reduce light
reflectio
Adjusting the Focus
Press Focus button to do an one-time
auto focus.
Adjusting the Brightness
Press Brightness button to increase or
decrease the brightness level.
Change the image
orientation
If your image is upside down, change the
image orientation by pressing “AF”( )
button and hold the button for 2 seconds.
+ Anti-glare
2 sec.

6
Basic Operation
Using Document Camera as a PC cam
Starting the application
1. Connect the document camera to your computer
Turn on your computer then connect the accessory USB cable to the USB port of your
computer.
Make sure the connector and the port are aligned correctly.
2. Launch PC Camera
After the document camera is correctly connected to and detected by your PC, you are
ready to use PC Camera function
Working with Documate
1. Install Documate software.
2. Connect device and PC with accessory USB cable.
3. Start Documate on your PC.

7
Troubleshooting
When using the document camera :
Problem Cause Solution
Cannot be powered
on normally.
The USB cable is not cor-
rectly connected to the
computer or computer
may have crashed.
Re-connect the USB cable with the
document camera.
Restart the computer.
No image output
after connecting.
The document camera is
not correctly connected to
the computer.
Re-connect the USB cable with the
document camera.
Software is not installed on
the computer.
Install the bundled sofeware on the
computer.
Application software is
incompatible with the
document camera.
Use the bundled sofeware to oper-
ate the document camera.
The image is fuzzy.
Probably the distance of
object is too close to the
lens.
Press AF button to auto focus.
Make sure the distance form the lens
to the subject is greater than 10 cm.
The image dose not
move.
The computer or applica-
tion software may have
crashed.
Restart the computer or aplication
software.
Noises occur when
viewing images on
the computer
The flicker setting does not
match the standard of the
country you are staying.
Adjust the flicker setting in software.
Freeze image or no
image showing in
Windows 7
The built-in decoder of
Windows 7 operating
system does not support
the image streaming
higher than 2592x1944
resolutions.
Download free Codec Pack from
internet. Such as K-lite Codec Pack.
This Codec Pack will install the
necessary decoder for Windows 7
to work on high resolution image
streaming.
http://www.codecguide.com/down-
load_kl.htm
The contents in this manual are subject to change without prior notification.