Intelimax MA-2020 User manual

Intelimax+ User Manual
- 1 -

Intelimax+ User Manual
- 2 -
TABLE OF CONTENTS
CONTACT INFORMATION ........................................................................- 5 -
RF EXPOSURE AND ELECTRICAL SAFETY COMPLIANCE ...........................- 6 -
Caution ........................................................................................ - 6 -
General Safety ............................................................................... - 7 -
Vehicle Safety ................................................................................ - 8 -
Potentially Unsafe Areas .................................................................. - 8 -
REVISION HISTORY..............................................................................- 10 -
Intelimax+ USER MANUAL ....................................................................- 11 -
Disclaimers .................................................................................. - 11 -
INTRODUCTION ....................................................................................- 12 -
Overview.........................................................................................- 12 -
Intelimax+ Features .......................................................................- 12 -
General Features .......................................................................... - 12 -
Extended Features........................................................................ - 12 -
Frequency Bands .......................................................................... - 12 -
Data Speeds ................................................................................ - 13 -
Physical ...................................................................................... - 13 -
Connections ................................................................................. - 13 -
LED Lights ................................................................................... - 13 -
Approvals / Compliance................................................................. - 13 -
Power Source............................................................................... - 13 -
Operating Systems ....................................................................... - 13 -
Intelimax+ Setup .................................................................................- 14 -
Connecting to the Intelimax+ .........................................................- 15 -
TCP/IP Connection - Recommended ................................................ - 15 -
Serial Port Connection................................................................... - 16 -
Modem Status Tab ..........................................................................- 17 -
WAN Configuration TAB ..................................................................- 19 -
Scheduler TAB.................................................................................- 24 -
Serial Configuration TAB .................................................................- 26 -
IP Stack Configuration TAB .............................................................- 28 -
Modem Emulation TAB ....................................................................- 32 -
Dynamic DNS ..................................................................................- 34 -

Intelimax+ User Manual
- 3 -
PPP Server ......................................................................................- 35 -
Administration TAB .........................................................................- 41 -
Telnet and SSH login .................................................................... - 41 -
Syslog ...................................................................................... - 41 -
RSSI logging................................................................................ - 43 -
Administrators ............................................................................. - 43 -
maXconnect................................................................................. - 43 -
System TAB.....................................................................................- 44 -
AT over IP ................................................................................... - 44 -
Debug ...................................................................................... - 45 -
Lock out ...................................................................................... - 45 -
SNMP Configuration ...................................................................... - 45 -
SNTP ...................................................................................... - 48 -
Other GUI functions ........................................................................- 49 -
Output Info.................................................................................. - 49 -
IP Stack Functions ........................................................................ - 49 -
System Functions ......................................................................... - 50 -
Firmware Upgrade ........................................................................ - 52 -
SMS Commands (IP modes) ............................................................- 53 -
SMS Commands (Serial modem modes) ..........................................- 54 -
Remote change from CSD mode to IP mode....................................- 55 -
LED Functionality ............................................................................- 57 -
Device Operation Checking / Debugging.........................................- 59 -
Telnet / SSH Commands .......................................................................- 60 -
Connecting to the modem via telnet ............................................... - 60 -
Extended / Intelimax+ Specific AT Command Set (IP Stack Modes) ....- 75 -
Device Information ....................................................................... - 75 -
AT Command Password Protection .................................................. - 75 -
WAN Extension Functions .............................................................. - 76 -
WAN Authentication ...................................................................... - 76 -
Periodic reset ............................................................................... - 77 -
WAN scheduler............................................................................. - 77 -
IP Stack setting............................................................................ - 78 -
SNMP ...................................................................................... - 78 -
DDNS ...................................................................................... - 79 -

Intelimax+ User Manual
- 4 -
System ...................................................................................... - 79 -
maXconnect................................................................................. - 80 -
Serial (UART) port ........................................................................ - 80 -
Engine Band ................................................................................ - 81 -
Check IP address of the WAN side .................................................. - 82 -
FTP ...................................................................................... - 83 -
Signal Strength ............................................................................ - 85 -
Open PPP connection .................................................................... - 86 -
Close PPP connection .................................................................... - 86 -
Open TCP/UDP Socket................................................................... - 86 -
Close TCP/UDP Socket .................................................................. - 86 -
Change Remote Server IP address.................................................. - 86 -
Change client/server mode ............................................................ - 86 -
IPStack Connection Settings .......................................................... - 86 -
Change modem mode ................................................................... - 87 -
Save and Reboot .......................................................................... - 87 -
Factory Reset............................................................................... - 87 -
Profile Save ................................................................................. - 87 -
Profile Set ................................................................................... - 87 -
AT over IP on IPStack ................................................................... - 87 -
Modem Emulation......................................................................... - 88 -
Modmax Compatibility Mode ...........................................................- 89 -
Prepare modem for hard shutdown.................................................- 91 -
SMS on Boot ....................................................................................- 91 -
Extended / Module Specific AT Command Set (IP and Serial Modes)....- 92 -
Save settings and reset/restart modem ........................................... - 92 -
Standard AT Commands for serial interface ..................................... - 92 -
Single AT command SMS AT+MMC SMSMO...................................... - 93 -
Prepare modem for hard shutdown ................................................. - 93 -
SMS on Boot ................................................................................ - 93 -
CSD and PSD/PPP dial out commands (Serial mode only) .................. - 94 -
Periodic Reset (Serial mode only) ................................................... - 94 -
Getting S0 value (Serial mode only) ............................................... - 94 -

Intelimax+ User Manual
- 5 -
CONTACT I NFORMATION
In keeping with Maxon Australia’s dedicated Customer support policy, we encourage
you to contact us.
TECHNICAL:
Hours of Operation: Monday to Friday 8.30am to 5.30pm*
Telephone: [phone]
Facsimile: [phone]
Email: [e-mail] * Public holidays excluded
SALES:
Hours of Operation: Monday to Friday 8.30am to 5.30pm*
Telephone: [phone]
Facsimile: [phone]
Email: [e-mail] * Public holidays excluded
WEBSITE: www.maxon.com.au
ADDRESS:
Maxon Australia Pty Ltd
36a Gibson Avenue, Padstow
Sydney, NSW, Australia 2211
POSTAL ADDRESS
Maxon Australia Pty Ltd
Po Box 1, Revesby North,
Sydney, NSW Australia 2212

Intelimax+ User Manual
- 6 -
RF EXPOSURE AND ELECTRICAL SAFETY
COMPLIANCE
The use of this device in any other type of host configuration may not comply with the
RF exposure requirements and should be avoided. During operation, a minimum of 20
cm should be maintained between the antenna, whether extended or retracted, and
the user’s/bystander’s body (excluding hands, wrists, feet, and ankles) (to ensure RF
exposure compliance.) The modem is not designed for, nor intended to be, used in
applications within 20 cm (8 inches) of the body of the user. Continued compliance of
the equipment relies upon it being used with an AS/NZS 60950.1 approved SELV power
supply.
Caution
Change or modification without the express consent of Maxon Australia Pty. Ltd. voids
the user’s authority to use the equipment. These limits are designed to provide
reasonable protection against harmful interference in an appropriate installation. The
modem is a transmitting device with similar output power to a mobile phone. This
equipment generates, uses, and can radiate radio frequency energy and, if not used in
accordance with instructions, can cause harmful radiation to radio communication.
The modem is approved for use with the antenna: ANT-SMA. Unauthorized antennas,
modifications, or attachments could impair call quality, damage the device, or result in
violation of RF exposure regulations.
There is no guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference in radio and television reception, which
can be determined by turning the equipment on and off, the user is encouraged to try
to correct the interference by one or more of the following measures:
Re-orient or relocate the receiving radio or TV antenna
Increase the separation distance between the equipment and the receiver
Contact Maxon Australia Technical Support for assistance.

Intelimax+ User Manual
- 7 -
General Safety
RF Interference Issues: Avoid possible radio frequency (RF) interference by carefully
following safety guidelines below:
Switch OFF the Modem when in an aircraft. The use of cellular telephones in
aircraft is illegal. It may endanger the operation of the aircraft and/or disrupt the
cellular network. Failure to observe this instruction may lead to suspension or
denial of cellular services to the offender, legal action, or both.
Switch OFF the Modem in the vicinity of gasoline or diesel fuel pumps or before
filling a vehicle with fuel.
Switch OFF the Modem in hospitals and any other place where medical
equipment may be in use.
Respect restrictions on the use of radio equipment in fuel depots, chemical
plants, or in areas of blasting operations.
There may be a hazard associated with the operation of your Modem in the
vicinity of inadequately protected personal medical devices such as hearing
aids and pacemakers. Please consult the manufacturers of the medical device
to determine if it is adequately protected.
Operation of the Modem in the vicinity of other electronic equipment may
cause interference if the equipment is inadequately protected. Observe any
warning signs and manufacturers’ recommendations.
The modem contains sensitive electronic circuitry. Do not expose the modem to
any liquids, high temperatures or shock. The modem is not waterproof. Please
keep it dry and store it in a cool, dry place.
Only use original accessories or accessories that are authorized by the
manufacturer. Using unauthorized accessories may affect your modem’s
performance, damage your modem and violate related national regulations.
Always handle the modem with care. There are no user serviceable parts inside
the modem. Unauthorised dismantling or repair of the modem will void the
warranty.
* The product needs to be supplied by a limited power source or the
power supply provided. Otherwise, safety will not be ensured
* Do not fixed the product in an open area where it is liable to lightning

Intelimax+ User Manual
- 8 -
strike hazard.
Vehicle Safety
Do not use the modem while driving.
Respect national regulations on the use of cellular devices in vehicles. Road
safety always comes first.
If incorrectly installed in a vehicle, the operation of the modem could interfere
with the correct functioning of vehicle electronics. To avoid such problems,
ensure that the installation has been performed by qualified personnel.
Verification of the protection of vehicle electronics should be part of the
installation.
Note: The user is cautioned that changes or modifications not expressly approved by
Maxon Australia could void the warranty.
Potentially Unsafe Areas
Posted Facilities: Turn off the device in any facility or area when posted notices require
you to do so.
Blasting Areas: Turn off the device where blasting is in progress. Observe restrictions and
follow any regulations or rules.
Potentially Explosive Atmospheres: Turn off the device when you are in any area with a
potentially explosive atmosphere. Obey all signs and instructions. Sparks in such areas
could cause an explosion or fire, resulting in bodily injury or death.
Areas with a potentially explosive atmosphere are often but not always clearly marked.
They include:
Fuelling areas such as gas or petrol stations
Below deck on boats
Transfer or storage facilities for fuel or chemicals
Vehicles using liquefied petroleum gas, such as propane or butane
Areas when the air contains chemicals or particles such as grain, dust or metal
powders
Avoid using the modem in areas that emit electromagnetic waves or enclosed

Intelimax+ User Manual
- 9 -
metallic structures e.g. lifts.
Any other area where you would normally be advised to turn off your engine

Intelimax+ User Manual
- 10 -
REVISION HISTORY
Product
Intelimax+ M2M 3G Serial Modem
Model
MA-2020
Document Type
PDF
Current Version Number
1.03
Status of the Document
Initial Release
Revision Date
July 2015
Total Number of Pages
94
-Revision History
Level
Date
History
1.00
April 2015
Initial Release Version
1.01
May 2015
LED function, AT password control, and minor GUI changes
1.02
June 2015
SNMPv3, SNMP Traps, GUI lock out and session timeout, partial
firmware update, bootloader update, secure syslog
1.03
July 2015
Factory reset process, profile set and reset, secure socket
connection