Intelligent Security 868SLH User manual

868SLH Keypad
Pleasenote:changingthechannelaccesscode (endusercode)firstwill
automaticallychangetheprogrammingcode(mastercode). Tohaveaseparate
Accesscodeandprogrammingcode, changetheprogrammingcodefirst.
Tochangechannelaccesscode.
Simultaneously press and hold buttons 1 & 3. After the three beeps, press
and hold buttons 4 & 6. After a further three beeps, enter the programming
code (factory default is 12345). After the long beep enter your new 5 digit
access code. After two beeps, enter the new code again. A long beep and the
lights going out signify that the code has been successfully changed.
Toteachacodetoadecoder.
Simultaneously press and hold 1 & 3. After the three beeps, hold buttons 1 &
2. After a further three beeps, enter your access code. After the long beep,
press and hold the required channel button (1,3 A or B). Also press and hold
the learning button on your decoder. After the LED on your decoder stays on
steadily, let go of your decoder button and then your keypad button. When the
lights have gone off on your keypad, enter your access code, then press the
channel button a couple of times and test that the decoder card is recognising
the channel.
Toteachacodetoatransmitter.
Follow the steps above. When you are holding down the required channel
button, put your transmitter next to the keypad. Press and hold the required
button on your transmitter. The LED on your transmitter will flash twice and
go out if it has successfully taken the code.
Totakeacodefromatransmitter.
Press P1 and P2 on your transmitter. When the LED flashes, let go. Then
press and hold the button you want to code to the keypad. Enter your channel
access code on your keypad and then press and hold the channel button
(1,3,A or B). Successful storage of the code is signified by a double beep and
the lights on the keypad going out .
• WARNING!Thefollowingprocess,oncecompleted,cannot
bereversed.Thekeypadwillnolongerbeabletogiveor
receivenew channelcodes!*
Tosetkeypadasaslave.
Simultaneously press and hold buttons 1 & 3. After the three beeps, press
and hold buttons 7 & 9. After a further three beeps enter your programming
code. After the long beep, your keypad is now a ‘slave’.
Tochangetheprogrammingcode.
IntelligentSecurity&FireLtd

Simultaneously press and hold buttons 1 & 3. After the three beeps, press
and hold buttons 7 & 8. After a further three beeps, press and hold buttons 8
& 9, after a further three beeps, enter your existing programming code. After
the long beep, enter your new programming code.
After the double beep, enter the new code again. After the long beep your
code has changed.
Toresetakeypad
To reset to the factory default, press and hold buttons 1& 3. After the beeps,
press and hold buttons 7 & 8. After a further three beeps, press and hold
buttons 2 & 0. After the next three beeps enter your programming code, After
the long beep, your keypad is reset.
N.BIfyouchangetheprogrammingcode,keepanoteofthe
codesomewheresafe.Thereisnowayofresettingthekeypad
withoutit.
IntelligentSecurity&FireLtd