Intermec EasyCoder 401 User manual

EasyCoder 401
Fan Fold Kit
P/N 1-960391-02
Edition 3
September 1998
Installation Instructions

EasyCoder 401 – Installation Instructions
1
EasyCoder 401
Fan Fold Kit
Installation Instructions
Edition 3, September 1998
Part No. 1-960391-02
Description
FAN FOLD KIT
Inadditiontotheinternalpaperroll,theEasyCoder401printerscan
also use thermal paper or receiving face material from an external
supply, e.g. an external paper roll or a stack of fan-folded tickets.
The paper is inserted into the printer through either the upper or
lower slot in rear plate.
Itisimportantthatthepaperwebisproperlyalignedinparallelwith
theprinter'scentre-linewall.Therefore,Intermecoffersanoptional
“Fan Fold Kit” consisting of:
• 1 Fan Fold Guide
• 1 Inner Guide
• 1 Outer Guide
• 2 Screws MRT 4 ×6 FZB
The kit also contains two guide shafts, each consisting of:
• 1 Break Shaft
• 2 Guide Rolls
• 1 Screw MRT 4 × 8 FZB
Theseguideshaftsareincludedforuseinotherprintermodelsthan
EasyCoder 401 and can be discarded.
Continued!

EasyCoder 401 – Installation Instructions
2
FAN FOLD KIT, cont'd.
Description, cont'd.
IMPORTANTPRINTHEADANDRIBBONINFORMATION
The use of any thermal transfer ribbons, other than those supplied by UBI, will invalidate
the printhead warranty. UBI thermal transfer ribbons are engineered specifically for this printhead.
The quality of thermal and thermal transfer media supplies in this printer is also of great importance
for the quality of printing bar codes and a long life of the printhead. UBI has carefully matched the
paper werecommend/provide to the needs of this printer. We therefore strongly advise of using
only UBI recommended/provided supplies to ensure a high quality printing.
TEAR-OFF
401
Fan Fold Guide assy.
Theguide bracketwith itstwo guidesis assembledbefore delivery
and can be fitted in the upper slot in the rear plate by means of two
screws. The outer guide is adjustable for different paper widths.
Note:
The lower slot in the rear plate can only be fitted with a fan fold
guideafterthecrescent-shapedguideplateinsidethepapersupply
roll has been removed.

EasyCoder 401 – Installation Instructions
3
The guide bracket with the two guides can be fitted either at the
upper slot in the rear plate.
Insertthecompleteunitthroughtheslotfromtheoutsideandattach
it to the rear plate by means of the two #T20 Torx screws included
in the kit.
Adjust the position of the outer guide to fit the width of the paper.
Installation –
Fan Fold Guides
FAN FOLD KIT, cont'd.
Continued!

EasyCoder 401 – Installation Instructions
4
Load the paper web according to the illustration below. Note that
the external supply should be protected from dust, sand, git and
otherparticlesthatmaydamagetheprintheadorimpairtheprintout
quality.
Paper Load Instructions
FAN FOLD KIT, cont'd.
Information in this manual is subject to change without prior notice and does
not represent a commitment on the part of Intermec Printer AB.
©CopyrightIntermecPTCAB,1998.Allrightsreserved.PublishedinSweden.
EasyCoder is a registered trademark of Intermec Technologies Corp.
Torx is a registered trademark of Camcar Division of Textron Inc.