
Setting up neoVI PLASMA for wireless access
This document covers the basics of setting up a neoVI PLASMA on a wireless network. ot all settings and
options are covered, but the key settings to configure the neoVI PLASMA for wireless network access are
reviewed.
Setup a 3G connection:
To use a neoVI PLASMA with a 3G connection, a SIM card and antenna are required. Start with the PLASMA
disconnected from power. The SIM card is inserted into the slot on the neoVI PLASMA, which can be found
on the lower right side of the unit (see Figure 1). The card only fits in one way. The card contacts will face
up and the notch side is inserted first. The antenna is connected to the SMA connector on the left, circled in
Figure 1.
Figure 1: Plasma Connections for GSM antenna (left) and SIM card (right)
When the neoVI PLASMA powers up, it should find and configure itself to the inserted SIM card. The
connection can be tested using the Browser app, found in the App drawer, to try and access the internet.
To verify or change the Access Point ame (AP ), open up the Mobile etwork settings. This can be done
using the following steps.
Figure 2: Press the App button Figure 3: Press Settings
1
neoVI PLASMA:
Wireless etwork Initial Setup