inVue ZA2720-W User manual

Zips
ZA2720-W Merchandising
Guide
Gently pry open the exibles sides
of the ZA2720 sensor to break the
adhesive bond between the sensor
and the Apple Pencil.
2
Remove the Pencil from the sensor.
3
Use a charged and coded OneKEY
to deactivate the inVue product that
the sensor is plugged into. For Zips
Alarm Units, place the OneKEY onto
the IR lens and press the button.
Then place the magnet key onto the
lock icon on alarm unit above the
sensor. Push in slightly and unplug
the sensor.
1a If using the S2865 system, place the
charged and coded OneKEY onto
the Remote IR Dot connected to the
system and press the button. Remove
the sensor from the S2865 Alarm/
Power Box.
1b
1
2
If reinstalling the Pencil, use an
alcohol wipe to remove any adhesive
residue. Allow it to dry completely.
4
CONTENTS: One pad saturated in 75%
Isopropyl Alcohol
DIRECTIONS: Apply topically as
needed to cleanse surface mounting area.
FOR EXTERNAL USE ONLY
KEEP OUT OF REACH OF
CHILDREN
KEEP AWAY FROM EYES
AND FIRE
Remove the old adhesives from the
sensor.
5
Use an alcohol wipe to remove any
adhesive residue from the inside
of the sensor. Use caution to not
damage the micro switch inside of
the sensor. Allow it to dry completely.
6

© 2022 InVue Security Products Inc. All rights reserved.
InVue is a registered trademark of InVue Security Products.
Rev0 08/11/22
www.invue.com
NA / LATAM // 704.752.6513 •888.55.INVUE
EMEA // +31.23.8900150
APAC // +852.3127.6811
Insert the new adhesives (ADH2149)
into the sensor, curving along the
interior contours. Ensure that the
pull tabs are in place and are folded
pointing up out of the sensor as shown.
Note: The sensor is now ready to be
reinstalled. Consult the installation
guide for more information.
7