iOpener RD20 User manual

RD20 RD40 SD10
The RD20 is perfect for exposed locations such
as perimeter doors and open carports. The RD20
is well suited for single roll up garage doors.
Minimum side room requirement: 40mm
Recommended side room requirement: 80mm
Peak lifting force: 550N
Typical travel speed: 100mm/sec
Receiver storage capacity: 8 x 4 button transmitter
Code combinations: 4.29+ billion random codes
The RD40 is an international standard in roll up
garage door automation. This more powerful unit
is well suited for larger double roll up doors.
The SD10 is a compact, yet powerful, opener
perfectly suited for use on single or double
panel garage doors.
Minimum headroom requirement: 57mm
Peak lifting force: 650N
Typical travel speed: 140mm/sec
Receiver storage capacity: 8 x 4 button transmitter
Code combinations: 4.29+ billion random codes
Door Type:
Single/Double
Car Roll Up
Max Door
Height: 2.7m
Max Door
Area: 13.5m²
Door Type:
Double Car
Roll Up
Max Door
Height: 2.7m
Max Door
Area: 15m²
Door Type:
Double Car Panel
Max Door
Height: 2.4m
Max Door
Area: 13.5m²
Warranty: 2 year or 5000 cycle warranty on drive unit.
12 months on other components and accessories. Please
read warranty terms in the enclosed manual for full details.
Warranty: 2 year or 5000 cycle warranty on drive unit.
12 months on other components and accessories. Please
read warranty terms in the enclosed manual for full details.
Warranty: 2 year or 5000 cycle warranty on drive unit.
12 months on other components and accessories. Please
read warranty terms in the enclosed manual for full details.
Weather Resistant: For installations where the
opener is exposed to the elements, the unit
is sealed to prevent damage from water (IP24)
Soft stop/start: Ramping speed up and
down at the start and end of each cycle of the
door reduces stress on the opener for longer
life and quieter operation and prevents a
“bang” when the door stops moving.
Soft stop/start: Ramping speed up and
down at the start and end of each cycle of the
door reduces stress on the opener for longer
life and quieter operation and prevents a
“bang” when the door stops moving.
Minimum side room requirement: 40mm
Recommended side room requirement: 80mm
Peak lifting force: 600N
Typical travel speed: 120mm/sec
Receiver storage capacity: 14 x 4 button transmitter
Code combinations: 4.29+ billion random codes
soft stop/start
soft stop/start
weather resistant
www.diyopener.com.au
DIY GARAGE DOOR OPENERS

DIY GARAGE DOOR OPENERS
ROLLER DOOR
INSTALLATION
SECTIONAL DOOR
INSTALLATION
1. Prep the door
2. Attach the weight bar
3. Raise one end of
the door
4. Slide the opener on
5. Set limits
6. Code transmitters
TOOLS REQUIRED FOR INSTALLATION:
• Ladder • Adjustable wrench • Socket set
• Drill • Screwdrivers • Marker pen
• Door stand (adjustable step ladder can be used)
• Towel or large piece of foam
IMPORTANT SAFETY WARNING:
While garage doors look safe, they can be VERY dangerous if not handled properly. They
contain springs that are under extreme tension and must be handled VERY carefully to
avoid injury. Please take a moment to read the safety information in the installation manual
before commencing the installation.
Please refer to the enclosed installation manual for details. Please refer to the enclosed installation manual for details.
1. Prep the door
2. Assemble the C-Rail
3. Attach the powerhead
to rail
4. Mount the opener
5. Set limits
6. Code transmitters
www.diyopener.com.au