1050 B-DP Quick Guide
INSPECTING AND REPLACING THE CENTRE BRUSH
• Unscrew the knob and open the door on the left of the machine.
• Unscrew the three knobs securing the brush compartment cover.
• Pull out the brush cover compartment.
• Remove the brush, holding it on the plastic core.
• Remove the adapter from the core of the old brush and t it to the new brush, taking care to keep the bristles
aligned in the same direction.
• Fit the new brush and make sure that the adapter is inserted on the drive hub.
• Replace the brush compartment cover using the knobs, following the dismantling operations in reverse order.
ADJUSTING SIDE BRUSH HEIGHT
• Move the side brush to the working position.
• Loosen the adjustment screws on the brush motor support.
• Manually move the brush to the required position.
• Tighten the adjustment screws.
Emptying the bin:
• Release the bin lock.
• Pull out the rear bin by means of
its handle.
• Take the bin (which is tted with
wheels) to the rubbish collection
point and empty it.
Daily maintenance:
When you have nished cleaning,
proceed as follows:
• Turn the machine off.
• Activate the parking brake.
• Raise the side brushes to prevent
damage.
• Recharge the batteries if
necessary, using the connector
provided.
Empty the debris bin
Check and remove any debris
wrapped around the side brushes and
on the centre brush.
Weekly maintenance:
Check the level of electrolyte in the
batteries, if using acid batteries.
Check that the suction lter is tight
and clean.
2
PLDC03834
IP Cleaning S.p.A. - Viale Treviso, 63 30026 Summaga di Portogruaro - www.ipcworldwide.com
+
+
+
+
+
-
-
-
-
-
Battery
