14 15
INSTALLING LUXEPORT
WALL BOX / RETROFIT INSTALL
Use a Stud Finder to
determine an unobstructed
location to mount LuxePort
WallStation. Use a 2-3/4”
(70mm) Hole Saw and cut a
hole in the desired location
on the Wall.
The next steps are for
drywall installation only. Discard
the Retention Ring if installing in
a solid surface such as wood
or concrete.
Step 1
Insert the LuxePort
Retention Ring in the wall
as shown. Starting with the
split end, insert one side
of the ring into the 2-3/4”
hole and rotate counter
clockwise until the ring is
all the way behind
the drywall.
Step 3
Use a wire fishing tool and
run new CAT5/6 cable to
power source location. Or
pull wire through the wall
from a previous run prior
to drywall.
Step 2
