iProtec LG110LR User manual

WARNINGS AND LABELS
AVOID DIRECT EYE EXPOSURE AB12A
This Laser Product is designated as Class 3R during all procedures of Operation.
· Wavelength: 650nm
· Laser Power for classification: <5mW CW
LASER LIGHT - AVOID DIRECT EYE EXPOSURE
CAUTION - use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous
radiation exposure.
DO NOT POINT LASER OR ALLOW LASER LIGHT TO BE DIRECTED OR REFLECTED TOWARD OTHER PEOPLE OR REFLECTIVE
OBJECTS. USE CAUTION AROUND FACE AND EYES.
IMPORTANT WARNINGS
Night hunting with artificial light may be prohibited or restricted in your state. Please check your state’s game laws for clarification.
FAILURE TO READ AND FOLLOW THESE OPERATING INSTRUCTIONS AND WARNINGS WHEN HANDLING A FIREARM OR THIS PRODUCT
CAN BE DANGEROUS AND CAN RESULT IN SERIOUS INJURY, DAMAGE TO PROPERTY, OR DEATH.
• Use of a firearm under any circumstance may be dangerous. SERIOUS INJURY OR EVEN DEATH may result without proper training in the safe
handling of firearms. Proper training should be obtained from an accredited firearms safety program conducted by competent, qualified instructors
in the military, police academies or National Rifle Association affiliated instruction programs.
• Read your firearm’s manual before attaching your gun mounted light.
• Never point a firearm at something you are not willing to destroy.
• iPROTEC recommends that this product should only be activated with the non-trigger hand while employing a two-hand grip on the firearm and with
the trigger finger outside the trigger guard when possible. Failure to do so could result in an accidental discharge and serious injury, damage to
property, or death.
• Thoroughly practice (employing safe training conditions) with this item and firearm before using the weapon in a tactical situation.
BEFORE ATTACHING, INSPECTING OR SERVICING A FIREARM-MOUNTED LIGHT/LASER
1. Engage the safety on the firearm if applicable.
2. Remove the magazine from the firearm if applicable.
3. Open the action and inspect the chamber to be sure it is empty.
IT IS IMPERATIVE THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES WHILE
HANDLING THE FIREARM.
MAINTENANCE
If the laser stops working, replace the batteries as shown.
A drop of 3-in-1 oil on the mounting hinge can be added to ease movement.
There is no other scheduled maintenance or service that can be performed by the user. Other than battery replacement, this product must not be
opened or modified by the user. If any repair or service is required, please return the product to Alliance Sports Group in accordance with the product
warranty.
BATTERIES
WARNING: FIRE, EXPLOSION, BURN HAZARD.
USE ONLY: USE only AAA Alkaline Battery. Use of other batteries or mixing of used and new or different brand batteries may result in leakage, fire
or explosion and serious personal injury. DO NOT recharge, misuse, short circuit, improperly store or discard, disassemble, or heat above 212°F
(100°C). Keep away from children.
USE ONLY THOSE BATTERIES SPECIFICALLY RECOMMENDED FOR USE IN THIS PRODUCT.
USER MANUAL
ITEM#6105
110 LUMEN LED LIGHT & LASER
WITH UNIVERSAL LONG GUN MOUNT
LG110L R
With Changes As is

BATTERY INSTALLATION
1. To open battery compartment, unscrew (counter-clockwise) the end cap/pressure switch end cap.
2. Remove battery cartridge.
3. Remove old batteries and dispose of properly. Insert new batteries making sure that the
negative end ( - ) is facing the spring. LG110LR is powered by 3 AAA batteries.
4. Reinsert battery cartridge into flashlight. Make sure battery cartridge is facing
the correct direction as shown.
5. Reattach end cap/pressure switch end cap by turning clockwise.
MOUNTING INSTRUCTIONS
ACCESSORY RAIL MOUNT
Caution: Make sure that the firearm has the safety on and is unloaded to avoid misfiring.
3. Tighten the mount onto the barrel and flashlight
using the latch of the mount.
4. Set the latch of the mount in the locked position
and test your flashlight for functionality.
1. Select a location on your long gun that will not
interfere with its intended
use of operation.
2. Place the two halves of the mount on either side of the
barrel and flashlight.
Universal Mount has a patented accessory rail mount system
for attaching additional firearm accessories.
The accessory rail mount gives you the ability to mix and match your favorite light
and laser accessories. Accessory rail mount measures 18mm x 24mm.
#6081 iPROTEC®Red Laser Firearm Sight shown (not included)
Visit www.iprotec.com to see all compatible iPROTEC®products.
Locked
Position
Unlocked
Position
Mount adjusts from
20mm to 32.5mm
PRESSURE SWITCH
Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (NiCad or NiMH)
batteries. Do not use rechargeable or reusable alkaline
batteries. Dispose of old batteries properly.
U.S. Patents: D 657,840 and D 659,869 S
All copyrighted and copyrightable materials, including,
without limitation, the logo, design, text, graphics,
pictures, copywriting and the selection and arrangement
("Materials") thereof are ALL RIGHTS RESERVED
Copyright © 2018 Alliance Sports Group.
The Exporting or Re-Exporting of U.S. Controlled items
without proper approval from the U.S. State or Commerce
Departments is strictly prohibited.
A standard end cap is provided for normal flashlight use.
STANDARD END CAP
HIGH: 110 LUMENS
Click the Side Button 1 time for 110 lumens of
white light.
Run Time: 7.5 Hours / Viewing Distance: 50 Meters
RED LASER
From the previous mode, click the side
button for red laser.
Run Time: 47.5 Hours / Viewing Distance: 412
Meters
LIGHT & LASER
From the previous mode, click the side
button for light and laser.
Run Time: 6.5 Hours / Light Distance: 50 Meters
Laser Distance: 412 Meters
DEFENSIVE STROBE
From the previous mode, click the side button for
Defensive Strobe Mode.
Run Time: 6.75 Hours / Viewing Distance: 50 Meters
HIGH
STROBE
RED LASER
LIGHT & LASER
For remote operation, the pressure switch uses a
momentary button to activate the light modes.
To navigate lighting modes with the
pressure switch, press (1) momentary
button to activate then press the
(2) side button to cycle through
the lighting modes.
ACTIVATION: The pressure switch activates the light mode that you
intend to use. Note: Light mode will only activate when pressure
is applied to the button.
NAVIGATION: The side button of the flashlight is used to
navigate through the different light modes.
QUALITY GUARANTEE
This product is guaranteed against all defects in workmanship and materials for the
original owner for one year from the date of purchase. Damage to or failure of the flashlight
or any component thereof due to alteration, misuse, battery leakage or lack of maintenance
will void any and all guarantees. Damage by leakage of batteries should be taken up with
the manufacturer of the battery using their damage claim instructions. For any additional
information call 1-800-255-6061.