iRobot Scooba 230 User manual

iRobot Scooba 230 Quick Start Guide
www.irobot.com
iRobot Scooba 230 Quick Start Guide
Scooba is designed for use on hard floor surfaces, including tile, linoleum, vinyl, marble, slate and
sealed wood. Do not use Scooba on unfinished or unsealed hard floors, stone floors, carpets, rugs or
waxed floors.
Step 1. Charge Scooba
Step 2. Prepare the room
1
1
Put in Scooba’s battery.
Sweep the floor
or run Roomba.
Plug in and charge
Scooba up to 8 hours.
(The charger flashes
twice when plugged in,
to show it has power.)
Remove clutter and area rugs in the room to be cleaned.
2
2
TIP: To extend the battery life, always store Scooba connected to a plugged-in charger.
NOTE: When Scooba is fully charged, the light on the charger is solid green.

iRobot Scooba 230 Quick Start Guide
www.irobot.com
Step 3. Set up Scooba
Step 4. Clean Scooba
1
Open both the Fill
and Empty Ports.
Slowly add warm
water in the Fill Port.
2
Add Scooba Hard
Floor Cleaner (either
one pre-measured
packet or one-half
of a cap full).
3
Firmly close the
Fill and Empty
Ports until
sealed.
4
Place Scooba in the
middle of the dirtiest
area of the floor.
5
Press the Power button
to turn on Scooba.
6
For short cycle,
press and hold clean
until second song
plays. (20 minutes,
up to 60 sq. ft.)
For the long cycle, press clean once.
(45 minutes, up to 150 sq.ft.)
1
Empty and thoroughly rinse both the Fill
and Empty Ports with water after each use.
2
Take off the bottom plate. Rinse and
remove debris from brushes and
squeegee.
3
Remove any debris on the robot before
replacing the bottom plate.
© 2011 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730. All rights reserved. iRobot and Scooba are registered trademarks of iRobot Corporation. [00027.0111.v1]
TIP: To protect bottom plate brushes, keep Scooba on storage mat, when not in use.
TIP: Use only Scooba Hard Floor Cleaner or tap water; other solutions may damage Scooba.
CLEAN
power