Page 2 of 4
1. Before installation check recovery points are
compatible with your vehicle.
2. Remove the front factory under trays.
3. Remove the 10 x bolts holding the two factory tie
down points, and disregard
4. Lift recovery point into position. Using 4 x M10
bolts, spring washers, and flat washers, loosly
attach recovery points using the holes illustrated.
5. Feed the 2 x nut plates with the short wire into
the radiator support mount to pick up the front
inner holes use 2 x M12 bolts, spring washers
and flat washers
