IRUS I108 User manual

System
®
exhibition
assembly instructions
for the exhibition stand I108
constisting of:
- 8x Aluminium prole à 1250 mm incl. bores
- 8x Aluminium prole à 1250 mm incl. adjustable foot and bores
- 14x Aluminium cross prole with pointed screws for the lower and upper mounting
- 7x Aluminium cross prole for the middle mounting
- 28x H-Proles à 1200mm to stabilize the panels
- 8x Extension bolt for aluminium prole
- 3x longarm lighting 450mm incl. replacement bulb
8x 8x 14x 7x
28x 8x 3x

System
®
exhibition
1. Mounting the lower area of the
corner with the aluminium cross
prole incl. pointed screws.
2. Then mount the middle cross
aluminium prole.
3. Further assembly of the lower
section with the aluminium cross
prole incl. pointed screws.
4. Then mount the remaining middle
cross aluminium prole and insert
the extension bolts into the prole.
Important during assembly
Pointed screws must be used for all proles that have holes.

System
®
exhibition
5. Slide the upper proles over the
extension bolts. Make sure that
the boreholes are upwards.
6. Then mount the remaining upper
cross aluminium prole.
7. Fully assembled exhibition stand.
If necessary, compensate for
uneven oors with the leveling feet.
.