IRUS I101 User manual

System
®
exhibition
assembly instructions
for the exhibition stand I101
6x 3x
10x
6x 5x
6x
20x
constisting of:
- 6x Aluminium prole à 1250 mm incl. bores
- 6x Aluminium prole à 1250 mm incl. adjustable foot and bores
- 10x Aluminium cross prole with pointed screws for the lower and upper mounting
- 5x Aluminium cross prole for the middle mounting
- 20x H-Proles à 1200mm to stabilize the panels.
- 6x Extension bolt for aluminium prole
- 3x longarm lighting 450mm incl. replacement bulb

System
®
exhibition
1. Mounting the lower area of the
corner with the aluminium cross
prole incl. pointed screws.
2. mount the middle cross prole.
Important during assembly
Pointed screws must be used for all proles that have holes.
3. Further assembly of the lower
section with the aluminium cross
prole incl. pointed screws.
4. Mount the middle cross proles
and then insert the extension bolt
into the proles.

System
®
exhibition
5. Slide the upper proles over the
extension bolts. Make sure that
the boreholes are upwards.
6. Mount the upper cross proles
incl. pointed screws
7. Fully assembled exhibition stand.
If necessary, compensate for
uneven oors with the leveling feet.