IRUS I104 User manual

System
®
exhibition
assembly instructions
for the exhibition stand I104
constisting of:
- 6x Aluminium prole à 1250 mm incl. bores
- 6x Aluminium prole à 1250 mm incl. adjustable foot and bores
- 10x Aluminium cross prole with pointed screws for the lower and upper mounting
- 20x H-Proles à 1217mm to stabilize the panels.
- 6x Extension bolt for aluminium prole
- 3x longarm lighting 450mm incl. replacement bulb
6x 6x 10x
6x 3x
20x

System
®
exhibition
1. Mounting the lower area of the
corner with the aluminium cross
prole incl. pointed screws. After
insert the extension bolts.
3. Now mount the upper aluminium
cross prole incl. pointed screws.
Important during assembly
Pointed screws must be used for all proles that have holes.
2. Slide the upper proles over the
extension bolts. Make sure that
the boreholes are upwards.
4. Further assembly of the lower
section with the aluminium cross
prole incl. pointed screws.

System
®
exhibition
5. Insert the remaining extension bolts and
slide the remaining upper proles over
the extension bolts. Make sure that the
boreholes are upwards.
6. Now mount the remaining upper
aluminium cross prole incl.
pointed screws.
7. Fully assembled exhibition stand.
If necessary, compensate for
uneven oors with the leveling feet.