IRUS I109 User manual

System
®
exhibition
assembly instructions
for the exhibition stand I109
constisting of:
- 8x Aluminium prole à 1250 mm incl. bores
- 8x Aluminium prole à 1250 mm incl. adjustable foot and bores
- 14x Aluminium cross prole with pointed screws for the lower and upper mounting
- 7x Aluminium cross prole for the middle mounting
- 28x H-Proles à 1200mm to stabilize the panels
- 14x PVC foam boards à 952 x 1212 mm
- 8x Extension bolt for aluminium prole
- 3x longarm lighting 450mm incl. replacement bulb
8x 8x 14x 7x
28x 8x 3x
14x

System
®
exhibition
2
1
3
4
5
6
7
2. Insert the panels with the H-proles
one after the other and mount them
immediately with the cross prole.
1. Mounting the lower area of the
corner with the aluminium cross
prole incl. pointed screws.
3. Further assembly of the lower
section with the aluminium cross
prole incl. pointed screws.
4. Insert the remaining panels with
the H-proles one after the other
and mount them with the cross prole.
Important during assembly
Pointed screws must be used for all proles that have holes.

System
®
exhibition
1
2
3
45
6
7
5. Insert the extension bolts into
the prole.
6. Slide the upper proles over the
extension bolts. Make sure that
the boreholes are upwards.
7. Insert the upper panels with the
H-proles one after the other and mount
them immediately with the cross prole
incl. pointes screws.
8. Fully assembled exhibition stand.
If necessary, compensate for
uneven oors with the leveling feet.