Isolite RWL-C EXIT User manual

Headquarters: 800-888-5483 • 610-647-8200 www.isolite.com Western Office: 800-799-5343 • 805-546-9669
RWL-C
EXIT & COMBO

1. Use flat head screwdriver to loosen the screws on the lens.
2. Remove lens, from sign, set aside.
3. Remove EXIT stencil from housing, set aside.
Drill a ¾” hole through the desired mounting knock out located on the frame of the sign. For ceiling mount,
knock out will be located on the top of the housing. For wall mount, knock out will be located on the side of
the housing.
INSTALLATION INSTRUCTIONS FOR EXIT AND COMBO
RWL-C Combo RWL-C Exit

4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
Isolite

BLACK 120VAC
LED BOARD
RED 277VAC
WHITE COM T R S
RED
BLACK
REMOTE
B A T.
RED
BLACK
RED
BLACK
DER )+(
KCALB )-(
BLACK 120VAC
LED BOARD
RED 277VAC
WHITE COM T R S
REMOTE REMOTE
B A T. 3.6V/1800mAH
3.6V/1800mAH
RED
BLACK
RED
BLACK
DER )+(
KCALB )-(
BLUE
BLUE
BLUE
BLUE
BLUE
BLUE
BLACK 120VAC
LED BOARD
RED 277VAC
WHITE COM T R S
B A T.
DER )+(
KCALB )-(
BLACK 120VAC
LED BOARD
RED 277VAC
WHITE COM T R S
BLACK 120VAC
LED BOARD
RED 277VAC
WHITE COM T R S
RED
BLACK
B A T. 3.6V/1000mAH
RED
BLACK
DER )+(
KCALB )-(
Exit Battery Wiring Diagram: AC Only Wiring Diagram:
Green(3.6V/500mAH)
Red(2.4V/500mAH)
Exit RC Wiring Diagram:
COMBO RC Wiring Diagram:
COMBO Wiring Diagram:
BLUE
BLUE
BLUE
BLUE

ATTENTION FOR WET LOCATION INSTALLATION
1. Instruction for seal ring installation
Peel off the paper
Place on the bracket
Press it to make sure it
is pasted properly
2 . Instruction for bracket installation
Tighten the screws
Make sure no gap between the
housing and bracket.
3 . Instruction for clear lens installation
Most important is to PUSH
the middle of the lens to
balance it when tighten
the screws
push
4. Instruction for seal foam installation
Peel off the paper
Paste properly
WARNING:Press the unit to make sure it is
locked onto the wall tightely.
Distance between bracket and
wall should less than 2mm.
5. Instruction for final installation 6. Adjust the angle of the lamp head and
tighten the screws
RWL-C
EXIT & COMBO
Headquarters: 800-888-5483 • 610-647-8200 www.isolite.com Western Office: 800-799-5343 • 805-546-9669