ITC elio TPB Configuration guide

3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: [phone] • www.itc-us.com • [email protected] • REV A 10/16/18
Flexible Light Install Instructions
(Part #’s: TPB, TPC, TPD, TPE, TSB, RBLL, RELL & RSLL)
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
*Disconnect power before installing, adding or changing any component.
*To avoid a hazard to children, account for all parts and destroy all packing materials.
*Use only with UL approved power supply.
Please visit www.itc-us.com for warranty info
2. Wire the light based on the wiring diagrams below.
1. Determine the installation location of your exible lighting. Lights
can be attached via the adhesive on the back (TPB, TPC, TPD &
TPE only) or with a mounting channel.
Mounting channels are available as screw or adhesive mount.
Install per your desired method. If using the screw mount
channel, screws should be used every 12”
Remove the paper backing from the light and press the light into
the channel.
Tape Light
Red (+)
Black (-)
Green (G)
Power Supply
24V - 110V
Neutral (N)
Load (L)
To 110V - 277V
Power
Positive (+)
Negative (-)
Tape Light
To 12V DC
Power
Black (-)
Red (+)
Black (-)
Fuse
PARTS/TOOLS NEEDED:
Flexible Light
UL Recognized
Power Supply
(purchased separately)
Mounting Channel
(purchased separately) Power Drill Butt Splice Connectors (not provided)
#4 Flat Head Screws
(not provided)

3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: [phone] • www.itc-us.com • [email protected] • REV A 10/16/18
3. Please review the considerations below to ensure a successful installation.
Only bend the wireDo not bend right at
solder joint
Do not horizontal bend to a radius of less than 11.8”
R11.8”
Do not bend exible light at 90° Do not bend to a radius of less than 1/2”
R0.59”
Do not axial bend to the height
of more than 0.312” within 0.78”
segment
0.78”
Less than 0.312”
Do not twist more than 90° over the length
of one 24V segment / Two 12V segments
(4” total length)
4”
Axis
*Flexible light cannot be eld cut. Field cutting the light will void the warranty.