iTOUCH KENDALL+KYLIE K+K Kween User manual
No power
Music is not playing
over Bluetooth
Bluetooth device will
not reconnect with the
headphone
Recharge your wireless bluetooth headphone using
the USBC cable.
Make sure your Bluetooth device has A2DP prole.
Check if both devices are paired and connected over
Bluetooth. Restart the headphone to reconnect your
Bluetooth device.
Navigate to your Bluetooth settings menu on your
Bluetooth device, tap “K+K KWEEN” ,and select
“Forget”. Now follow the steps to pair your device
again. Or, press & hold the power button on the
headphone (while powered on) to disconnect the
headphones from any connected devices. Then follow
the steps to reconnect your device.
Headphone User Guide
CHARGING
• On the right earcup,carefully plug the USB-C cable into the USB-C charging port and
connect the other end of the cable to either a computer USB port or to a UL certied
USB wall charger.
• Solid red LED light will appear to indicate when the headphone is charging.
• When charging is complete, the LED light will turn Blue.
• Charging time is approximately 1.5 hours.
PAIR & CONNECT WITH A NEW DEVICE
• Power on the wireless bluetooth headphone (refer to the“Turn It On”section).
• To pair the headphone with a new device,ensure the device is not connected to any
other device. The red & blue LED light will blink to indicate it is ready to be paired
with a new device.
• On your Bluetooth-enabled smartphone, tablet or media player, navigate to the
Bluetooth settings menu, turn on Bluetooth and search for new devices. After a few
seconds you will see “K+K KWEEN” listed.
• Tap this model to select it. A solid blue LED light indicates your device has
successfully paired.
• With your previously paired device’s Bluetooth turned on and in range, the
headphone will automatically reconnect to the last Bluettooth device it was
connected to.
NOTE: If the headphone is not used within 5 minutes, the headphones will automatically turn
o to save battery.
BUTTON FUNCTION
• Press area (refer to product Diagram) to turn up the volume.
• Press area (refer to product Diagram) to turn down the volume.
• Press and hold area (refer to product Diagram) to skip to the next track.
• Press and hold area (refer to product Diagram) to return to the previous track.
• Press area (refer to product Diagram) to use your connected devices Voice
Assistant.
TROUBLESHOOTING
PLAY
• Connect your device to the headphone via Bluetooth (refer to the ”Pair & Connect”
section)
• Open your favorite music app and press play.
• Control the music, track & volume from your device or from the controls on the
headphones. Press the Power button once to play/pause music & answer calls. Press
it twice to redial the last number called on your phone and press & hold it to reject
an incoming call.
• All audio, including music, games, videos and notications will be routed through
the headphone.
TURN IT ON / OFF
• Press & hold the power button on the right side of the headphone for about 3
seconds until the LED indicator light turns on.
• Press & hold the power button again for 3 seconds until the LED light turns o.
FCC ID: 2ARUI-KKWEEN
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation. Warning: Changes or modications not expressly
approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit dierent from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
RF Warning Statement: The device has been evaluated to meet general RF
exposure requirements. The device can be used in portable exposure conditions
without restriction.
Previous Track / Volume Dowm
Voice Assistant
USB-C Charging Port
LED indicator
Press Once: Play/Pause, Answer/End Calls
Double Click: Re-dial Last Dialed Phone Number
Press & Hold (1-2 Sec): Reject Incoming Call
Microphone
Press & Hold (3 Sec): Power On
Press & Hold (3 Sec): Power O
Next Track / Volume Up
3.5mm jack
WARRANTY: This limited warranty gives you specic legal rights and you may also
have other rights, which vary from state to state.
For all warranty information please visit:
itouchwearables.com/pages/warranty-policy
DO NOT RETURN PRODUCT TO THE
STORE FOR SERVICING
FOR TECHNICAL ASSISTANCE, WARRANTY AND
CUSTOMER SERVICE, CALL:
+1 (888) 200-6081
PLEASE VISIT US AT:
www.itouchwearables.com
Other iTOUCH Headphones manuals
