iZone TwinXL User manual

Head Section
Foot Section
G. Washer
(4 pcs)
H. Nylon Washer
(8 pcs)
J. Wrench
(1 pc) Note. Some
hardware comes
preinstalled.
I. Hex Key
(1 pc)
A. Platform Frame
(1 pc)
B. Head Section
Motor Rail (1 pc)
C. Motor with Attached
Remote Control (1 pc)
D. Mattress Guard (1 pc) E. Leg (4 pcs) F. Connector Bracket (1 pc)
Adjustable Platform Frame
TwinXL/King Size
Contains One (1) Frame and Hardware
Carefully remove all parts from the box. Arrange on a at surface
and verify you have all of the following parts and hardware.
PARTS LIST
HARDWARE LIST
ASSEMBLY INSTRUCTIONS
(Continued)
Unfold the frame (Part A) and lay it upside down.
Attach the head section motor rail (Part B) to the
head of the frame using the preinstalled screws
and nylon washers (Part H).
STEP 1 STEP 2
Motor
attachment
point
D
VIEW LOOKING DOWN
White nylon washers
(Part I) installation
(2 locations)
VIEW LOOKING FORWARD
White nylon washers
(Part I) installation
(2 locations)
Familiarize yourself with the platform frame
(Part A). Wood slats on the frame are divided
into sections by hinges which allow the bed to
adjust. The head section has 4 wood slats and
the foot section has 6 wood slats.
IMPORTANT NOTES:
1. Never sit directly on the head or foot sections of
the bed when they are not in the at position.
2. Two wooden replacement slats have been included
with this base. Do not throw them away. Store these
replacement slats in a safe place for future use, if needed.

12
Foot end of the frame
STEP 3 STEP 4
STEP 6
ASSEMBLY INSTRUCTIONS (CONTINUED)
Attach the four legs (Part E) using one washer
(Part G) for each leg.
Connect the backup battery to the motor as
shown in Position 1. The backup battery allows
you to return the frame to a at position in the
event of a power outage. Only connect the
backup battery as shown in Position 2 in the event
of a power outage.
STEP 5
STEP 7
Note.
Turn the frame upright. Using
the preinstalled wing nuts, install
the mattress guard (Part D) on
the foot end of the frame.
Some wood slats in the middle
of the frame have plastic sliders.
You can make the frame more
plush by moving these sliders
closer together, or more rm by
moving the sliders farther apart.
If you are using two TwinXL frames together as a
King size bed, attach the frames to each other using
two Connector Brackets (Part F). Each TwinXL frame
comes with one bracket.
Motor may be
slightly dierent
than shown
http://www.youtube.com/watch?v=1teZXf80Zrs
Scan the QR code on your smart phone or
device, or enter the link below to watch a
complete video of the easy assembly of the
Adjustable Platform Frame.
D
Stickers on the motor identify the head and foot
ends of the motor. Be sure the motor is facing the
right direction and line it up with the attachment
point on each motor rail. Push down on the head
end of the motor until you hear it snap into place.
Repeat for the foot end of the motor. Reinstall the
two plastic covers which were removed from the
motor in Step 4.
Slide the two plastic covers as shown to completely
remove them from the motor. Once removed, the
exposed openings will allow you to secure the motor
to the attachment points on the motor rails in Step 6.
Head end
of the frame
Foot end
of the frame
Motor
attachment
point
Motor
attachment
point
Center of the frame
More plush
More rm