J.Burrows Hilton Visitor Chair JBHILTVBF User manual

Hilton Visitor Chair
This chair has a load rating of 130kg
JBHILTVBF/JBHILTVBK

Assemble Item On A Clean Flat Surface
F (M6 x 16mm) G (1/4" x 3/4")
x 1
x 2 x 4
H(1/4" x 1")
X2
X2
I
x 8
C
C1
C2
J
x 8

Note: Join the Left Support(C1) & Right Support(C2)and Connector(D) together using 2
Bolts (F) as shown. Do not tighten the bolts until step 2.
Note: Align assembled Support over pre-drilled holes on the underside of Seat Cushion (B)
using 4 Bolts (G).Tighten all bolts(including the ones on connector) securely with
enclosed Allen Wrench (I). Be careful not to cross thread bolts or damage the seat.
2
1
J

Note: Attach Armrests (E) to the assembled Seat Cushion (B) using 4 Bolts (H) with
Allen Wrench (J) .Do not tighten Bolts fully until you have completed assembly.
Note: Attach Back Cushion (A) to Armrests (E) by securing 2 Bolts (H) to the lower
holes of Back Cushion (A) as shown. Do not tighten Bolts fully until you have
completed assembly.
H
H
JH
J
H

Note: Gently pivot the Back Cushion (A) to the upright position. Then fix Back Cushion (A) with 2
Bolts (H) by Allen Wrench (J). Ensure all the Bolts (G) are tight with Allen Wrench (J).
Your Hilton Vistor Chair is now complete and ready for use.
IMPORTANT NOTE: Periodically check and re-tighten screws
Australia
Officeworks Superstores Pty Ltd 236-262 East Boundary Road East Bentleigh 3165
Your Eton Visitor chair is now
complete and ready for use
J
H
H
I