J D Williams PD488 User manual

RATTAN SOLAR PILLAR LIGHT
Assembly Instructions - Please keep for future reference PD488
Important – Please read these instructions fully before starting assembly
IMPORTANT - This product has been designed for non-professional,
domestic use only.
IMPORTANT - Dispose of all packaging correctly and responsibly and
in accordance with all local laws and regulations. Never leave packag-
ing components within reach of children as they can be a source of
danger.
IMPORTANT - Carefully unpack and examine the product for any
damage. If you think there is a defect, do not use the product
IMPORTANT - This is a class 3 product low voltage product , battery
powered and not request power supply connection.
WARNING - Do not modify or alter any product before or after installa-
tion. This may render the product unsafe.
WARNING - This product is not intended for use by persons (including
children) with reduced physical, sensory and mental capabilities, or
lack of experience and knowledge, unless they have been given super-
vision or instruction concerning use of the product by persons responsi-
ble for their safety.
WARNING - Children should be supervised to ensure that they do not
play with the product.
Safety Information
BATTERY SAFETY INFORMATION
• Do not dismantle, open or shred the battery.
• Do not expose the battery to heat or fire.
• Avoid storage in direct sunlight.
• Do not short-circuit the battery.
• Do not subject the battery to mechanical shock.
• Keep the battery out of the reach of children.
• Keep the battery clean and dry.
• Do not leave a battery on prolonged charge when not in use.
BATTERY CAUTION
The lithium rechargeable battery used in this device may present a
risk of fire or chemical burn if mistreated. Do not Disassemble, short
circuit, crush, expose to heat above 60°C or incinerate.

INSTALLATION
Installation
Dia.1.
1. Place the fitting on the required position
turn the switch bottom from the solar
panel on and test the fitting.
The LED light only can operate under a dark
atmosphere.
Battery Replacement (If required).
Dia.02.
1. Using a screw driver (not supplied),
un-screw the side screws to separate
solar panel box from the plastic round
support.
2. Using a screw driver (not supplied),
un-screw the screws from the solar
panel box.
3. Open the box and remove the old
battery.
4. Insert new battery and close the box.
5. Re-screw all the solar panel box screws
6. Attach solar panel box to the plastic
round support screwing the side screws.
This product is suitable to use Lithium-Ion
battery cell or Li-Ion, abbreviated LIB only,
any other batteries type are not accepted.
Cleaning
- Use a clean dry soft or slightly damp cloth.
- Do not use abrasive cloths or polishes as this may
cause damage to the product.
APPROVED
06/11//2019
ISSUE 1
Q.C
Maintenance
PD488
J D Williams & Company Limited is part of N Brown Group plc. Griffin House, 40 Lever Street, Manchester, M60 6ES
Dia.1
Dia.2