5. Set Up Process
1. Plug in the power supply for the transmitter and receiver. Once the transmitter and
receiver has booted up, you will have a blue static “STA”light. Once the transmitter and
receiver has made a good connection, you will have a blue static “LINK”light.
2. Connect the source to the HDMI transmitter input port.
3. Connect the HDMI receiver to a display device (such as high-definition TV or projector).
4. Connect the 3.5mm standard IR cable to transmitter” IR OUT “port and receiver “IR IN”
port.
5. Make sure the transmitter and the receiver are placed in the final positions, clear of any
walls.
6. If you see a consistent flashing blue “STA”light, then data is being transmitted and received
properly.
6. Pairing the transmitter and receiver
1. Plug the power supply into the transmitter.
2. Plug the power supply into the receiver.
3. Connect the 3.5mm audio cable to transmitter and receiver. Please make sure both ends
are firmly in their ports.
4. Once you see the static blue “STA” light, press the receiver’s “RESET” button once, then
press the transmitter “RESET” button once. The “LINK” light should come on and start
flashing showing a connection.
**Pairing process is only necessary when setting up a second receiver
6. Unpairing the transmitter and receiver
1. Plug the power supply into the receiver.
2. Once you see the static blue “STA” light, press the receiver’s “RESET” button and hold until
“STA” turns off. After a few seconds, the “STA” light will come back on. The “LINK” light
will remain off, which means the receiver is unpaired.
