Jabuga REM mobile children's loft bed User manual

Assembly Manual
REM mobile children’s loft bed
combination with slide and rope
bridge

Thank you for choosing our product!
Our products are unique and hand made pieces of furniture, therefore the
assemblance requires a greater deal of manual skill. Before getting down to
work, please read through this manual in order to properly prepare for the
assembly work. Also, you will need at least one extra helping hand, and a day
off to comfortably finish the job.
In case you get stuck during the assembly, do not hesitate to contact us via our
etőségeinken, ahol segítségére leszünk.
If you do not feel comfortable enough about your handicraft skills, we
recommend that you hire a specialist to perform the job.
We wish you the best of luck in assembling this loft, which will give pleasure to
your child for many years.
Kindest regards:
Jabuga

Alignment
This assembly manual has been prepared based on a left alignment. In
case of right alignment, you should not interpret literally the leg markings
of the bed, but you should rather identify the applicable matching
elements based on the floor plan.

Floor plan

Checklist of components
Please check if you have found all the
necessary component parts in the package.

Components
Barrel nut and bolt, m8*100 60 pcs

Alkatrészek
Barrel nut and bolt, m8*80 2 pcs

Components
Threaded rod, underlay, nut, cap 1 of each

Components
Screws, 5*70 7 pcs

Components
Screws, 4*70 40 pcs

Components
Screws 4*50 6 pcs

Components
Screws, 3*40 14 pcs

Components
Hand-wheel 2 pcs

Necessary tools
You will need a No. 4 imbus key, a straight screwdriver,
an electric screwdriver with PZ 2 and PZ 1 hex bits and a
No. 13 fork spanner. A tape measure and an H4 imbus
bit may also come in handy.
H4
PZ1
PZ2

Necessary tools
In case you do not possess an electric screwdriver, a drill
with screwdriving function or in last case, a simple hand
screwdriver may do the job as well.

Necessary tools
At the end of the work, you may feel a great need for a
relaxation drink.

Important information!
As a result of individual, hand made threading, pine chips and shavings may
remain in the thread hole which could be driven into the screw hole by the inserted
screw. These holes are checked by us in all cases, but for security reasons, you should
also follow the following steps.
We ask you for this because if these chips and shavings get into the screw
hole, or, for any reason, even one screw gets stuck, the node may become
disassmeblable, hence the furniture may be useless!
If a screw gets stuck, never force it!
If this happens, please unscrew the screw and turn the opening of the bolt 180
degrees. If required, disassemble the node and check again the threads.
For checking, please follow the following steps:

Important information
Insert the screw horizontally into the empty thread hole.
Check to see if there are any pine chips in the hole.

In case you found any pine chips in front of the screw,
place the screw into the vertical thread, and use it as a
rasper, to get rid of the shavings. Blow out the remaining
shavings.
Important information

Once you have made sure that the threaded hole is now
clear, place the bolt into the vertical hole. Be careful to
have the slot on the top and hole of the barrel nut
pointing toward the horizontal thread.
Important information