Jackon Jackoboard r 600 User manual

JACKODUR®, JACKOBOARD®and JACKOCARE®are registered trademarks of JACKON Insulation GmbH. Errors and omissions excepted; subject to change. Art.-No. 4507845 01/2017

Shelf unit.

Modula R 600

Installation Instructions

Installation Instructions JACKOBOARD®Modula R 600

A B

Components

4 x shelves (A)

1 x shelf (B)

2 x side walls (C)

Accessories

1 x former board

20 x stainless steel screws

20 x stainless steel washers

2 x adhesive

Tools

Screwdriver

Cartridge gun

Installation Instructions JACKOBOARD®Modula R 600

2) Insert the shelf into the groove on the side wall. Make

sure the shelf and side wall are flush.

4) Apply adhesive to both joining parts (side wall and

shelves).

6) Screw both side walls of the unit tight by positioning

the enclosed screws and washers in the pre-drilled holes.

Using a manual screwdriver, tighten the screws until the

heads are flush with the surface.

1) Apply adhesive to both joining parts (side wall and shelf).

3) The shelves are glued on one after the other. The 80 mm

shelf is positioned second from the bottom to match the

washstand.

5) Position the second side wall so that each tongue fits

into the grooves. Make sure the side wall and shelves are

flush.

Installation Instructions JACKOBOARD®Modula R 600

Notes

BOARD-FIX®adhesive guarantees the permanent bon-

ding of the shelf unit components and is therefore a cruci-

al element of the assembly. The purpose of the screws is

to facilitate assembly.

BOARD-FIX®adhesive is usable for about 10 minutes af-

ter application. We therefore recommend that you adhere

to the sequence in these instructions when assembling

the washstand.

8) The shelf unit is now complete. Once the adhesive has

cured (approx. 24 hours) it can be directly covered with

tiles or plaster. To ensure permanency, the shelf unit must

be bonded to the base (wall and oor) using BOARD-FIX®

adhesive. Please observe the following notices.

7) Press the former board into the upper compartment of

the shelf unit. This serves to keep the shelf unit at right

angles and is removed once the adhesive has hardened.

JACKODUR®, JACKOBOARD®and JACKOCARE®are registered trademarks of JACKON Insulation GmbH. Errors and omissions excepted; subject to change. Art.-No. 4507845 01/2017

Please note