Jade JD-WD10 User manual

It is a smart water detector , adopts RF 433MHz technology
design with low power consumption and long battery life . Detector
separate from the sensor , it effectively prevent the impact of high
temperature environment on the product. It has the advantages of high
precision and sensitivity, long-term stability and reliability . It is widely
used for water leakage and overflow detection in the basement,
computer room, hotel, kitchen, toilet etc.
Alarm current
Transmitting frequency
Transmitting distance
Working Condition
＜20mA
100m (in the open area)
-10℃～+50℃
Wall mounted to install the water detector in the position needs to be
monitor. When the two feet of detector was immersed by the water, it
gives flash and send alarm message to the control panel.
Fix the base on the wall
with double gummed
paper (double gummed
paper installation).
When the alarm panel is in the matching code state, using water or
metal short cut the two feet of the water detector, it could matches code
with the control panel.
1. Fix the sensor on the area of water leakage easily happens.
2. Do not fix the sensor with plenty of water vapor or rain.
3. Do not fix the sensor in the water immersion place.
4. Though the water detector can reduce accident, it does not insure
perfectly safe. For your security, please enhance security
consciousness in daily life besides using this product correctly.
Fix on the wall with
double gummed
paper or screw.
WIRELESS WATER
DETECTOR MANUAL
Before install the water detector, please take reference of the
manual to make sure you could use it correctly.
PRODUCT SUMMARY
GENERAL VIEW
Front side Back side
SPECIFICATION
Working voltage DC 3V(CR2450 battery)
Stand-by current < 5uA
Installation
CODE MATCHING
NOTICE
433.92±0.5MHz

Warning：
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter.
