Agilent Technologies G8610 Series Reference guide

Agilent Technologies Helium Leak Detector
G8610, G8611, and G8612 Series Quick Reference Card
Manual Number G8610-90000, Rev. C
November 2017
Start Up (Manual Section 1.3.4)
Installation: Do not install or use the pump in an environment exposed
to atmospheric agents (rain, snow, ice), dust, aggressive gases, or in
explosive environments or those with a high fire risk. During operation,
the following environmental conditions must be respected:
•Temperature: from +12 °C to + 45 °C
•Relative humidity: up to 90% (non-condensing)
Plug in power cord, flip switch ON behind unit.
Wait about 7 minutes for "SYSTEM READY."
First time startup will
prompt a wizard to help
select language, units,
date, time, and options.
These may be changed
any time through the
menu screens.
Calibration Set Up (Manual Section 4.1)
•Read Internal Leak -Quick check to see if instrument reads
calibrated leak correctly
•To Calibrate:
1. Select Internal Leak and Full.
2. Tap Calibrate.
3. Tap OK when calibration is complete.
Menu Navigation (Manual Section 1.5)
Calibration
Calibrate with
Internal/External
Leak
External leak to be placed on Test Port or vacuum system.
Internal leak is provided instrument.
Calibrate
Full/Fast
Full Spectrometer Calibration/
Fast Gain Adjustment
Test
Configuration
Set Points
Set Point: Leak Rate, Pressure, Audio
Advanced
Features
High Pressure Test, Fine Test Only,
Auto-Zero < 0, Gross Test, Transfer Points (to Test),
Stabilization Wait Time
Application
Setup
Sniff Method, Spray Method,
High Sensitivity, Auto Sequencer,
Split Flow, PPM Sniff Method
Settings
Main Settings
Date and Time, Units, Languages, Touch, and Sound
Screen Settings
Bar Graph, Range, Analog Output
Remote Control
Remote Setup with Channel Sync
Password and
Restrictions
Restriction Level, Lock Vent Control, Lock All Control
Maintenance
General
Internal Calibrated Leak Setup, Software Update
Manual Tuning
Emission, Ion, Gain Settings
Valve Control
Manually Open and Close Valves
Pump
Inspect Forepump and Exhaust Pump
Gauge
Calibration
Calibrate Thermocouple Gauge to Vacuum or Atmosphere
System Defaults
Set to Factory Defaults
System
Information
System
Information
Software Version, Internal Data
Current Setup
Set Points and Calibration Type
Turn Off
Turn Off
Turbo will brake. Do NOT move leak detector while turbo is
powering down.

Agilent Technologies Helium Leak Detector
G8610, G8611, and G8612 Series Quick Reference Card
You must consult operations manual, p/n G8610-90001, provided with
the leak detector, in order to operate the equipment in a safe manner.
Main Controls (Manual Section 1.5)
•Test -Measure helium leak rate
•Hold -Isolate leak detector from connected vacuum system while keeping both under vacuum
•Zero -Nullify current leak rate reading and establish a new baseline
•Vent -Bring test port to atmospheric pressure
Home Screen Display (Manual Section 1.5 and 3.11)
Application Setup (Manual Section 5.1.3)
Shutdown (Manual Section 1.3.5)
Tap the Power icon and follow the prompts.