Jalo Helsinki Kupu Series User manual

screw installation
Kupu

Pull the red
battery-Protection
taPe away.
1

Make Marks
for screw holes.
You can direct your smoke alarm with the
aid of the direction arrow. The direction
arrow should point in the same direction
as the sides of the smoke alarm.
2

drill holes for
the screw anchors.
Please use Ø 6mm drill bit.
3

Place the screw anchors
into the drilled holes.
4

Place the install
Plate to ceiling.
Remove the installation plate of the
smoke alarm by turning it counterclock-
wise and lifting it away.
5

insert and drill the
screws in Place.
You can direct your smoke alarm with the
aid of the direction arrow. The direction
arrow should point in the same direction
as the sides of the smoke alarm.
6

Press kuPu against the
installation Plate and
turn it clockwise.
You can make small changes in the
position of the smoke alarm by turning
it a few degrees in the direction you want.
7

installation is done.
Congratulations - you have made your
home a safer place.
8

for more our
products visit
www.jalohelsinki.fi