Jaypro Sports PB-80PI User manual

JAYPRO SPORTS
7 ½’ PERMANENT PLAYER’S BENCH WITH BACK REST, PB-80PI
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 AR5044 Bolt Clip With Slot 8
2 AR5045 End Cap 4
3 HB5030 Carriage Bolt 5/16”-18 X 3” 10
4 EP0018 2” x 2” End Plug 4
5 HS5035 #8 Pan Head Screw x ½” 8
6 HN5046 5/16” Flange Nut 10
7 AR5046 Seat Plank 2
8 80PI1 Leg 2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench Or Adjustable Wrench (1)
1) Slip the end caps (2) snugly onto each end of the plank (7). Using the electric drill,
assemble a self-drilling screw (5) through the cap and into the flange of the plank.
Two screws are required per end cap.
2) For easiest assembly, position seat plank (7) on a level raised surface such as a desk
top, bleacher seat or work bench. Place the carriage bolt (3) and bolt clips (1)
approximately into place within the slots of the plank. Note that the legs should be no
more than 8” from the plank edge. Also assemble a bolt (3) and a nut (6) through the
lowest hole in the leg extension to help lock the leg in the footing.
3) Position the legs as shown and loosely assemble the hardware illustrated in detail ‘A-
A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright and assemble the backrest plank (8) as illustrated. Level the
bench and make sure the legs are adequately spaced apart. Tighten all fasteners fully.
5) Locate your bench and dig footings to the dimensions shown on the illustration.
Mark each leg at 18” from bottom of leg.
6) Fill in footings with concrete, then, lower assembled bench into the footings. Block
up under bench to support the bench at the mark on each leg. Level seat plank and
adjust bench as necessary.
7) Allow footings to cure at least 72 hours before removing the supports or using the
bench.