JB INDUSTRIES DV-22N Setup guide

JB INDUSTRIES
TMWWW.JBIND.COM 800.323.0811 [email protected]
CONNECT WITH US
DV-40S
DV-40
DV-22N
Digital Micron Gauge
Cleaning & repair Instructions
for DV-22N, DV-40, & DV-40S

Tools
Rubbing alcohol*
Step 4
Dump excess alcohol.
Step 1
Liberally pour rubbing
alcohol into the sensor.
Step 5
Repeat steps 1-4 at least
twice.
Step 2
Cover tting opening
with your thumb or
nger.
Step 3
Agitate the rubbing
alcohol in the sensor
to clean by shaking for a few
seconds.
Step 6
Allow to air dry or pull
vacuum on gauge to
expedite drying.
Cleaning the sensor
Use Isopropyl (Isopropanol) alcohol only. Do NOT use Denatured alcohol as it leaves
residue after evaporation. Do not use other solvents as they may be too corrosive
and permanently damage the sensor and or its surroundings. Isopropyl of 90% pure
or better should be used. Hardware stores will sell 99% pure, found near the paint
thinners & solvents.
2
If your micron gauge is acting erratic, for instance, vacuum readings at atmosphere, readings rising
and falling during a steady pull down or holding vacuum, cleaning the sensor may be necessary.
After following steps 1-6 if you’re still experiencing issues, an alternate method to clean
the sensor is to soak the sensor in alcohol overnight.
TM
DIGITAL MICRON GAUGE CLEANING & REPAIRS
JB INDUSTRIES

If you have trouble getting an accurate reading after cleaning the sensor, please check your o-ring for
damage, wear, or to see if it is missing.
Tools
O-ring probe or thin implement & P90009 Replacement O-ring.
Step 3
Place O-ring in the grove.
Step 4
Press O-ring to securely
seat it in the groove.
Step 1
Using probe get under
the rubber O-ring.
Step 2
Remove O-ring.
Replacing the O-Ring
TM 3
DIGITAL MICRON GAUGE CLEANING & REPAIRS
JB INDUSTRIES

©2016 JB Industries, Inc.
JB INDUSTRIES INC.
Aurora IL 60505 USA
TM
CONNECT WITH US
WWW.JBIND.COM