jcb 66-40E User manual
Electric TLT
QUICK REFERENCE GUIDE
This Quick Reference Guide DOES NOT replace the Operators
Manual. You MUST read ALL the disclaimers and safety and other
instructions in the Operators Manual before initially operating this
product. Accordingly, no legal claims can be entertained based on
the data, illustrations or descriptions in this Quick Reference Guide.
Access additional information
www.servicepro.jcb.com
Instrument Panel
Static Dimensions
Cab and Switch Panel
A. Ignition switch
B. Emergency stop button
C. Instrument panel
D. LLMI
E. Cab heater control
F. Lift arm control lever
G. Switch console
H. Park brake switch
J. Seat
K. Steering wheel
L. Brake pedal
M. Accelerator pedal
N. Diagnostic connector
P. Load chart
Q. Power socket
A. Warning and notification symbols
B. Display screen
A. Dynamic information screen
B. Battery level status
C. Drive selection
D. Battery percentage
E. Menu navigation
Start Up Sequence
Drive Selection Switch
A. Drive selection switch
F = Froward
N = Neutral
R =Reverse
BEST PRACTICES
1. Carry a load as low as possible while maintaining good
visibility.
2. Forks should be tilted back when in transport –with or
without a load, cradle the load.
3. Fork tips should be on the ground when unit is parked.
Moving Machine
A. Securing method
Static Dimensions
A. Lifting point x 4
B. Padding
Lifting Machine Tie-Down Points
Home Screen
Interlocks Screen
In order for machine to start:
•Operator seated
•Park brake applied
•Machine in neutral
Revision 1.0
1/6/2021
Access Covers
Install Fork Attachment
Install Bucket Attachment
Single Lever Control Console Switches
Longitudinal Load Movement Indicator (LLMI)
A. Boom raise
B. Boom lower
C. Boom extend
D. Boom retract
E. Carriage tilt forward
F. Carriage tilt back
G. Carriage tilt roller
A. Horn
Auxiliary Circuit Controls
A. Auxiliary vent
B. Auxiliary 1/2
C. Thumb switch
A. Green colour LED
B. Amber colour LED
C. Red colour LED
D. Override button , White colour LED
E. Calibrate button, White colour LED / Test
button
F. Amber/Green LED
A. Front work light
•1x press = work lights
•2x press = extra work lights
(option)
B. Eco mode
•Eco1 = 90% power
•Eco2 = 80% power
•Eco3 = 70% power
C. Up (in display)
D. Back (in display)
E. Side lights
F. Front windshield wiper
G. Rear work light
H. Joystick isolation/lock out
J. Down (in display)
K. Select
L. Hazard warning
M. Rear heated screen
Rear Cover
A. Latch
A. Release handle
B. Rear cover
C. Latch
A. Stowage position
B. Locking position
C. Locking pin
To lift cab to access motors and drive components, see
manual for details
A. Jack
B. Tilt lock pin
C. Cab bolts
D. Front cover
E. Cover plate
Service Points
A. Hydraulic oil filler cap
B. Hydraulic oil level indicator
C. Battery
D. Washer bottle
E. Battery isolator
Battery Replacement/ Maintenance
