JCM Technologies SESAME Instruction Manual

Rapid Installation Guide
SESAME
The solution for adding connectivity to the "M8NF" control panels
1.Connection
Connect the SESAME device to your M8NF control panel (use the RJ-45 connector). The
LED status should be flashing green and the LED network should be flashing red, which
shows that the device needs to be configured.
2.WIFI Connection Configuration
1.Using your smartphone, go to: Configuration/Set Up -> Wi-Fi & Networks -> Wi-Fi(search for: SESAME_
XXXXXXXXXX, no password is required).
2.Configure the SESAME_XXXXXXXXXX connection: the website for configuration will appear immediately (if not,
enter192.168.4.1 into your browser):
•2.1. Search for your home Wi-Fi signal (the signal should be Good or Poor for optimum efficiency)
and enter your home Wi-Fi password.
•2.2. Wait until the three LED lights will remain steady green, indicating that the WiFi connection was
successfully established. This operation may take a minute.
3.Downloading SESAME
Download the "Sesame" app from "JCM Technologies, S.A." using PlayStore if using an Android device, or go to the App Store
if using an iOS smartphone.

jcmtechnologies
4.Registration
Open the Sesame application and register or log-in to start a session
5.Adding a door
1.In order to add a door, press the "AddDoor" button on the app and enter your "SESAME ID" (see the label on the
SESAME device: "Activation Key" -> the guides are introduced automatically). Example: XXXX-XXXX-XXXX-XXXX
2.Enter the licence information for your door in order to begin managing it. There are two licences in the box. The
licences are renovated every 5 years. If you need more licences, please contact your distributor.
6.Administer your Door
7.Resetting the device
Reset the device if changing the Wi-Fi network or your Wi-
Fi password. To reset SESAME, press the WPS/ RESET
button for 10 seconds, with the device connected. The
LED “Status” will be set to green, and “Network" and "Inter-
net" to flashing red. Stop pressing the button when "Inter-
net" goes off and "Network" is fixed to red.
EU Conformity Declaration
JCM TECHNOLOGIES, S.A. hereby states that the SESAME product fulfils all the essential requirements of EU Directive RED 2014/53/EU and Directive RoHS
2011/65/EU.
See the web page www.jcm-tech.com/declarations/
JCM TECHNOLOGIES, SA • C/Costa d'en Paratge, 6B - 08500 VIC (BARCELONA) ESPAÑA
QG_3201188_SESAME_EN_Rev01