JDS Uniphase DSAM User manual

Cloning DSAM’s
Soft keys
METER # 1 METER # 2
To send settings from Meter #1 to Meter #2:
1.) Connect the meters
The Ethernet port is located at the top of the meter. Use an Ethernet crossover cable to
connect the meters.

.
4.) On the
SELECT WHICH
SETTING TO SEND Screen,
use the arrow keys and Select
softkey to select(or deselect) the
configuration groups you intend
to clone.
5.) To Move to the next key, press
OK
6.) On the
READ
Y TO CLONE
screen, Press Done.
7.) Prepare
METER
#2
for
cloning
8. On Meter #2 (cloning meter)
– WHAT WOULD LIKE TO
DO ? screen, use the arrow key
to highlight receive settings
from another meter.
9.)To begin press the SELECT
softkey
2.) Prepare
METE
R #1
for
cloning.
3.) On the CLONE- WHAT
WOULD YOU LIKE TO
DO? Screen, use the arrow
keys to highlight send from
this meter and press Select
softkey.
Under the Configure Screen
on METER #1 and METER
#2 highlight clone.

10. Meter #2 will receive data
from Meter #1