Jenn-Air JXW9036W Parts list manual

PRODUCT MODEL NUMBERS
ELECTRICAL REQUIREMENTS
A 120 Volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required.
LOCATION REQUIREMENTS
Have a qualified technician install the range hood. It is the installer's
responsibility to comply with installation clearances specified on the model/serial
rating plate. The model/serial rating plate is located inside the range hood on the
rear wall of the range hood.
Canopy range hood location should be away from strong draft areas, such as
windows, doors and strong heating vents.
For Mobile Home Installations
The installation of this range hood must conform to the Manufactured Home
Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal
Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or
when such standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI
A225.1/NFPA 501A*, or latest edition, or with local codes.
VENTING REQUIREMENTS
A 10" (25.4 cm) round vent
system is needed for
installation (not included).
The hood exhaust opening is
10" (25.4 cm) round.
NOTE: Flexible vent is not
recommended. Flexible vent
creates back pressure and air
turbulence that greatly reduce
performance.
Vent system can terminate
either through the roof or
wall.
Calculating Vent System Length
To calculate the length of the system you need, add the equivalent feet (meters)
for each vent piece used in the system.
The maximum equivalent vent lengths are:
10" (25.4 cm) round vents - 60 ft (18.3 m)
30" (76.2 cm), 36" (91.4 cm) and 48" (121.9 cm) Commercial Style
Wall-Mount Canopy Range Hood
Because Whirlpool Corporation policy includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. W10274316
10/08/09
JXW9030W
JXW9036W
JXW9048W
Roof Venting
A. Roof cap
B. 10" (25.4 cm)
round vent*
A. Wall cap
B. 10" (25.4 cm)
round vent*
A
A
B*
B*
Wall Venting
Example vent system
The following example falls within the maximum recommended vent
length.
PRODUCT DIMENSIONS
Front view
Back view
Vent Piece Equivalent Length
45° elbow 2.5 ft (0.8 m)
90° elbow 5.0 ft (1.5 m)
1 - 90° elbow
1 - wall cap
8 ft (2.4 m) straight
= 5.0 ft (1.5 m)
= 0.0 ft (0.0 m)
= 8.0 ft (2.4 m)
Length of system = 13.0 ft (3.9 m)
90 elbow 6 ft (1.8 m)
2 ft
(0.6 m)
Wall cap
CL
18¹⁄₁₆" (45.9 cm) for 48" (121.9 cm) Hood
12¹⁄₁₆" (30.6 cm) for 36" (91.4 cm) Hood
9¹⁄₁₆" (23.0 cm) for 30" (76.2 cm) Hood
18" (45.7 cm)
12" (30.5 cm)
30" (76.2 cm)
36" (91.4 cm)
48" (121.9 cm)
2¹⁄₄"
(5.7 cm)
6¹⁄₂" (16.5 cm)
25" (63.5 cm)
A
. Top of hood
B. Wood support
C. Bottom of hood
D. Home wiring location
E. Knockout into terminal box
A
B
C
D
CL
E
18¹³⁄₁₆" (47.8 cm) for 48" (121.9 cm) Hood
12¹³⁄₁₆" (32.5 cm) for 36" (91.4 cm) Hood
9¹³⁄₁₆" (24.9 cm) for 30" (76.2 cm) Hood
18"
(45.7 cm)
8³⁄₈"
(21.3 cm)
9⁷⁄₈"
(25.0 cm)
Page 1 of 2

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. W10274316
10/08/09
Optional Full-Width Duct Cover Installations
A. Optional full-width duct cover
B. Vent hood
12"
(30.5 cm)
18"
(45.7 cm)
12"
(30.5 cm)
A
B
Installation Dimensions
IMPORTANT:
•Minimum distance “X”: 30" (76.2 cm)
•Suggested maximum distance “X”: 36" (91.4 cm)
A. 84" (213.4 cm) minimum for
installations with canopy only.
B. 96" (243.8 cm) minimum for
installations with optional
duct cover.
13" (33.0 cm)
18" (45.7 cm) min.
clearance upper
cabinet to countertop
36" (91.4 cm)
countertop height
30" (76.2 cm), 36" (91.4 cm),
or 48" (121.9 cm)
cabinet opening width
(If installed between cabinets)
A B
Bottom of canopy
to cooking surface
Min. cabinet
opening width
tneVrevo
cd
e
su
f
i()
y
p
onaC
X
Page 2 of 2