Jensen JAHD240BT User manual




InstructionDisclaimer

Dennis Kirk provides instructions to help our customers better understand how to install the
products we sell. The instructions are exact copies of what the manufacturer includes with the
product being sold.
That means the quality and accuracy of the instructions is solely dependent on what the
manufacturer produces. We do our best to make the text legible and the pictures viewable.
However, the end result depends largely on the quality of instructions the manufacturer
provides.
Therefore, you will find that some instructions are not of the highest quality. Sometimes text is
hard to read and pictures are not easy to see. At times you will find the overall look of the
instructions to be less than professional. However, we feel it is better to provide what we have
rather than provide nothing at all.
To the best of our knowledge the instructions and application information contained in the
instructions is accurate. However, Dennis Kirk assumes no liability related to any errors that
may be contained in the copy of the manufacturer’s instructions we provide. Buyers are solely
responsible to insure that product use is consistent with their application.
If you have any questions please contact us at [email protected] or
800-969-7501 so we can further assist you regarding additional product information or any other
business related questions.
Thank you for doing business with Dennis Kirk.

JAHD240BT Waterproof
Features
˙Bluetooth Audio (A2DP)
˙2 x 40 Watt Max Power Rating
˙2 x 20 Watt RMS
˙4 Ω – 8 Ω (ohm) Stable
˙Frequency Response: 20 Hz – 20 kHz
˙Epoxy Potted Enclosure
˙10 Amp Fuse in Waterproof Holder
˙Waterproof to IPx6
˙Corrosion Resistant to ASTM B117
Wiring
Black
Ground
Yellow
+12V Battery
Red
+12V Switched
Gray
Right Front Speaker +
Gray / Black
Right Front Speaker –
White
Left Front Speaker +
White / Black
Left Front Speaker –
Installation
1. Choose a smooth, flat, sturdy location that
will allow the JAHD240BT amplifier to be
mounted securely and allow enough room
to run the connection wires.
2. Mount amplifier using #8 stainless steel
screws (not included)
3. Drill 5/8” hole in desired location, install
switch and route cable from desired location
to the amplifier
4. Route and connect power, ground, and
speaker cables (see reverse page)
Important:
Do not mount unit where it can be submerged
Do not mount near engine or areas exposed to
excessive heat
Yellow
Red
Black
Gray/Black
Gray
White/Black
White
Bluetooth Antenna
DO NOT CUT/CONNECT
10 A Fuse
Switch Cable
Switch Cable
Power/Pairing Switch
#8 Stainless
steel screws
Heavy Duty 2-Channel
Bluetooth Audio
Amplifier