JL Audio Stealthbox SB-D-5GRAMCCF/12TW3 User manual

INSTALLATION GUIDE
for the
SB-D-5GRAMCCF/12TW3
SKU# 94669
2019-Up Dodge Ram 1500 Crew Cab
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.
With proper installation, your new vehicle-specific enclosed subwoofer system
will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your
authorized JL Audio dealer. The installation professionals employed by your
dealer have the necessary tools and experience to disassemble and reassemble
your vehicle properly. If you prefer to perform your own installation, please read
this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely
vital that the Stealthbox®be properly mounted to the vehicle
according to these instructions. Failure to mount the enclosure
properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the
enclosure caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a
collision or sudden deceleration.
INSTALLATION
D IFF ICU LT Y:
ESTIMATED TIME:
1 HOUR
Enclosure Type: Sealed
Driver Type: 12TW3-D8
Nominal Impedance: 2 ohms
Continuous Power Handling: 800 watts (RMS method)
Continued on Next Page
15
OUT
OF
SB-D-5GRAMCCF/12TW3 INSTR_SKU# 011530

INCLUDED HARDWARE
4
3
2
1
Continued on Next Page
Page 2 • JL Audio, Inc., 2019
SB-D-5GRAMCCF/12TW3 INSTR_SKU# 011530
BOM ID Qty SKU Description
1 1 154040 Bracket
2 4 151096 3/8” Flat Washer
3 4 151081 3/8” Split Lock Washer
4 4 151079 3/8 - 16 x 1-1/4” Hex Head Bolt

POWER RECOMMENDATION
JL Audio recommends high quality ampliers such as the JL Audio XD600/1v2. The diagram below shows the recommended crossover settings for the XD600/1v2. For a detailed description of the
amplier settings, consult the owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.
CONNECTIONS
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your
Stealthbox® amplier. Other kits are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for
both channels of the amplier. JL Audio recommends using 12 AWG speaker wire for subwoofers such as our XC-BCS12-25.
Continued on Next Page
Page 3 • JL Audio, Inc., 2019
SB-D-5GRAMCCF/12TW3 INSTR_SKU# 011530

Page 4 • JL Audio, Inc., 2019 Continued on Next Page
STEP 8
Connect speaker cable to the terminal cup on
the back of the enclosure, and lower the
enclosure back into position. Reinstall the two
factory inner seat bracket bolts, and fully
tighten.
Route the speaker cable as necessary.
STEP 7
While holding the Bracket in its position,
carefully lift the enclosure, then fully tighten
the four 3/8 - 16 x 1-1/4” Hex Head Bolts.
STEP 6
Place the Stealthbox® into the vehicle. Center
the enclosure, and align the two upper slots in
the Bracket with the factory inner seat bracket
bolt holes.
STEP 5
Place the enclosure on a flat surface with the
woofers facing upward. Align the four slots in
the Bracket with the threaded inserts on the
back of the enclosure, as shown.
Slide a 3/8” Split Lock Washer and a 3/8” Flat
Washer over each of two 3/8 - 16 x 1-1/4” Hex
Head Bolts, pass an assembly through each of
slots in the Bracket, into the threaded inserts,
and hand tighten.
STEP 4
Using an E12 socket and wrench, remove the
two inner seat bracket bolts.
STEP 3
Locate the two inner seat bracket bolts.
STEP 2
Fold the seat bottoms up.
STEP 1
Empty the rear seat area.
SB-D-5GRAMCCF/12TW3 INSTR_SKU# 011530

Page 5 • JL Audio, Inc., 2019
CONGRATULATIONS!
You have completed the installation for this model! Enjoy your new Stealthbox®!
All specifications are subject to change without notice. “JL Audio®” and “How we play®”are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo are trademarks
of JL Audio, Inc.
Printed in USA • ©2019 JL Audio, Inc. • For more detailed information please visit us online at www.jlaudio.com.
[phone]
www.jlaudio.com
JLA-SKU# 011530 • ver. 10.29.2019 • 10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
®
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will t in the factory speaker locations of your vehicle.
Location / OEM
Speaker Size
Suggested JL Audio Speaker Models
Coaxial Models Component Models
Front Dash /
3-1/2-inch C2-350x C7-350cm
Front Doors /
6 x 9-inch
C1-690x(1), C1-690tx(1), C2-690tx(1)
C2-650x(1), C5-650x(1)
C1-690(1), C1-650(1),C2-650(1),
C3-650(1), C5-650(1), C7-650cw(1,2)
Rear Doors /
6 x 9-inch
C1-690x(1), C1-690tx(1), C2-690tx(1)
C2-650x
(1)
, C5-650x
(1)
C1-690(1), C1-650(1),C2-650(1),
C3-650
(1)
, C5-650
(1)
, C7-650cw
(1,2)
1 - Installation may require adaptor, 2 - Component woofer only
STEP 9
Fold the seat bottoms back down.
SB-D-5GRAMCCF/12TW3 INSTR_SKU# 011530