2008.4
■ To release this function, remove everything from the hook and press the TARE key. Then
the TARE LAMP will turn off and this function is terminated.
● NOTE: The weight including TARE weight cannot exceed the maximum capacity
6.4 HOLD FUNCTION
This function is performed whenever you weight an item.
■ Press HOLD to hold the weight being displayed. For accuracy considerations, only press
HOLD when weight is stable.
■ After HOLD is pressed, weight value will be fixed.
■ To release weight value being held, press HOLD again then the scale changes from Hold
mode to Normal mode.
6.5 RECHARGING THE SCALE
When low battery signal appears, apply the AC adapter to recharge the battery. Fail in
doing may cause irrecoverable damage to the rechargeable battery.
■ Check the voltage of battery charger before use.
■ Connection scale with adaptor
■ Turn ON the switch on the battery charger, charging will start with RED lamp (CHARGE)
turn on.
■ When the charging is completed GREEN lamp (FULL) turns on.
■ Estimated time for charging is 8 hours.
(Charging time can be vary according to the battery condition)
6.6 REMOTE CONTROL
■ Pressing the corresponding key on the remote control can attain same control results.
■ Do not knock or tap the remote control
■ Replace the battery once the remote control is not functional for distance 6 meters
(and below) away from the scale.
■ Clean the display windows of the scale as this has effect on the remote control
7. DAILY CARE AND MAINTENANCE
a. Avoid exposing scale to direct sunlight or excess moisture.
b. Do not submerge scale in water or drop scale.
c. Remove all loads from hook before transportation
d. Clean the sale with a soft and damp cloth, if necessary with mild detergent.
e. Do not use any harsh, abrasive materials, violate solvent thinner or alcohol for cleaning.
f. Verify the accuracy of scale periodically. Re-calibrate the scale when needed.
g. Store scale in a dry and cool place.
JLG User Manual 6
