JMband JMB4+ User manual

T4+ series user’s manual
Version: 1.2

JMB4+ user’s manual
1
Table of contents
1. Introduction............................................................................................................3
1.1 In the box......................................................................................................3
1.3 JMB4+ Printer Features............................................................................4
1.3.3 JMB4+ Front view .............................................................................4
1.3.4 Rear view............................................................................................4
1.3.5 Interior view........................................................................................5
2. Getting start...........................................................................................................6
2.1 Loading the ribbon.....................................................................................6
2.2 Loading the media ...................................................................................10
2.4 JMB4+ Connecting interfaces...............................................................13
2.4.1 USB Slave........................................................................................13
2.4.2 Ethernet (Option).............................................................................13
2.5 Power on the printer................................................................................14
2.6 JMB4+ Control Panel...............................................................................16
3. Printer options.....................................................................................................18
3.1 Peeler installation (Optional, not supplied).......................................18
3.2 Cutter installation (Optional, not supplied).......................................26
4. Specifications......................................................................................................31
4.1 General specifications............................................................................31
4.2 USB port pin assignment.......................................................................34

JMB4+ user’s manual
2
Introduction
1.1 In the box
After unpacking, please inspect carefully and make sure that you receive all
the necessary parts as below:
Printer
Core for foil take-up
Quick start guide
USB cable
Power Cord
Power adapter
External carrier for media
A
B
C
D
E
F
G
If any parts are missing, please contact the service department of your
distributor.
Save the carton and all packing materials in case you need to reship back.

JMB4+ user’s manual
3
1.3 JMB4+ Printer Features
1.3.3 JMB4+ Front view
1.3.4 Rear view

JMB4+ user’s manual
4
1.3.5 Interior view

JMB4+ user’s manual
5
2. Getting started
2.1 Loading the ribbon
1. Pulling the release latches on two sides toward the front of printer to open
the printer cover.
2. Open the ribbon cover by pushing the ribs (as shown in green) of ribbon
cover. Do not open the ribbon cover by pushing the cover edge which
installed the blade to tear off the label. It might hurt your hands if you push
it hard.

JMB4+ user’s manual
6
3. Insert the ribbon roll to the supply spindle.
4. Rotate the supply hub until the notches align and lock in to the left side of
supply hub.

JMB4+ user’s manual
7
5. Insert an empty media core into the take up spindle. Rotate the take up hub
until the notches align and lock on the left side of take up hub.
6. Pull the ribbon out from the roll and stick it with the adhesive tape on the
empty ribbon take up core.

JMB4+ user’s manual
8
7. Rotate the take up hub on the left side of ribbon spindle till the ribbon is
pulled tight.

JMB4+ user’s manual
9
Note: The loading path of ribbon roll (outside wound)