Johanson Decibel Clamp wall User manual

Clamp wall
Assembly instructions

12
3
Secure the bracket in place with
suitable screws.
Check to make sure that the bracket
is perfectly horizontal.
Then mark the position of the fixing
screws.
Slide the sound absorber into place in
the bracket.

Clamp floor
Assembly instructions

40 mm
Fit the sound absorber in place on
the frame using the 3 wood screws
supplied.
Make sure that the outside edges of
the sound absorber project 40 mm
beyond the frame.

Clamp ceiling
Assembly instructions

1
2
3
4
12
34
Fit the wires so that the end stops
slot all the way into the counterbore
on the bracket.
The sound absorber is supplied with
the following components for assebly:
1. Bracket
2. Wire with adjustable cable lock (3 pcs)
3. Ceiling fitting
4. Assembly screws (4 pcs)
Adjust the sound absorber, so that it
is centred in the bracket.
Slide the sound absorber into place
in the bracket with the reverse side
facing the wires.

5 6
78
Slide the adjustable wire locks into
place on the three wires. To release
the wire, simply press the end of
the lock. This makes adjusting the
length of the wire easy.
Use the two small wood screws
supplied to secure the sound absor-
ber in place on the bracket.
Mount the roof bracket with the
supplied wooden screws.
(Other attachment may be required
for porous material).
While supporting the sound absor-
ber, hook it in place on the ceiling
fitting, as shown in the photo

910
11
Use the wire locks in the hooks
to adjust the length and angle.
Surplus wire can be snipped
o after the necessary adjust-
ments have been made.
Installed and ready for use. Installed and ready for use.