Johnny's Selected Seeds GA3 User manual

SEEDLING CART
ASSEMBLY INSTRUCTIONS
CODE STAND PARTS GA3 GA4
R Slide rod 2 2
TB Top bracket 1 1
E End frame 2 2
P Plant tray 12 16
SS Short spacer 2 2
T Tee 12 16
L Long piece 2 4
PF Platform 2 2
BAG KIT
WI Wheel & insert 4 4
S Screw 16 20
N Nut 10 14
DW Domed washer 2 2
GC Ground cord 1 1
C Screw cover 2 2
NOTE: Take long pieces Land place tees Ton the ends and align the holes. Put a screw Sthrough the holes
and start a nut Non the screw S. This will be the middle shelf/shelves.
1. Place a tee Ton the end of a platform PF and align the holes. Put a screw Sthrough the holes, and start a
nut Non the screw S. Repeat on other three ends. This will be the top shelf.
2. For the bottom shelf, place a tee Ton the end of the remaining platform PF and align the holes. Put a
screw Sthrough the holes and start screw into the threads in the short spacer SS. The short spacer SS
should be a tight fit between the platform PF ends, and the indented hole should be on the outside.
Continue on the other three ends.
3. Place the wheel inserts into the bottom of the endframes E. The endframe ends should be distorted, tapping
may be necessary.
4. Place the end frame E(with the indented hole on the INSIDE) through the tees Tof the top shelf, then the
middle, and finally the bottom shelf. Repeat with other end frame E
5. Position the top shelf as desired and tighten the screws S, (use a large flat head screwdriver). Place the
remaining shelves where desired and tighten the screws S.
6. Insert a screw Sinto the top hole of the end frame E. With the head of the screw on the outside, hang slide
rod Rover the screw (on the INSIDE of the stand). Thread the screw into the top bracket.
7. Position the bottom of the slide rod Ron the outside of the short spacer SS. Place a screw Sthrough the
hole on the short spacer SS (with the head of the screw on the INSIDE) and between the slide rod Rends.
Put a domed washer DW on the screw Swith the indented side towards the slide rod Rends. Install and
tighten a nut N. Place a screw cover Con the end of the screw S. Repeat on the other end.
8. Insert the wheels firmly until locked in place. Place the plant trays Pon the shelves. Level the shelves by
loosening the screws and adjusting the tees T.

CODE PART CODE PART
C Screw cover PF Platform
DW Domed washer R Slide rod
E End frame S Screw
GC Ground cord SS Short spacer
L Long piece T Tee
N Nut TB Top Bracket
P Plant tray WI Wheel, & Insert
To Prevent Electrical Shock: Connect the eyelet of the enclosed
ground cord to any bolt head. The other end should be connected to
a ground point such as a water pipe or center screw of a grounded
outlet. Please disconnect fixtures when watering plants.
GC
DETAIL OF TEE
C
N
PF
S
T
N
L
T
(ROD ON INSIDE)
INSIDE)
S
D
W
(ROD ON
T
SS
R
E
S