JohnsonSuisse LISTO CC BTW JSTL400 User manual

LISTO CC BTW
SMART SHOWER TOILET
JSTL400
Installation Instructions
KEEP OUT OF REACH OF CHILDREN.
THIS PRODUCT CONTAINS BUTTON BATTERIES.
Dispose of used batteries immediately. The battery is
hazardous! If swallowed, a lithium battery can cause
severe or fatal injuries within 2 hours. If you think
batteries may have been swallowed or placed inside
any part of the body, seek immediate medical
attention. Contact the Australian Poison Information
Hotline on 13 11 26 or National Poisons Centre NZ
on 0800 764 766.
WARNING

2

3
- The product must be installed by a licensed electrician according to AS/NZS 3000 - Australian wi-
ring rules.
- Before installation, read this installation manual thoroughly and the included safety precautions. Parts
must be installed according to the instructions.
- Rain water or grey water is not suitable to operate this equipment. The Listo Smart shower toilet
shower toilet may only be operated with normal drinking water.
- Do not damage electrical connection components.
- The recommended water supply pressure is 150 KPa to 500 KPa. Operate equipment within the re-
commended water pressure.
- Water supply temperature must be between 10 - 30ºC. Ensure the correct water temperature is main-
tained.
- Do not use a water supply hose other than the one provided with this product.
- Make sure that this product is correctly earthed to ground. (If the product is not earth-connected, there
is a risk of electric shock).
- Dual check valve must be tted before cistern stop.
- Please note that this product has an Integral High Hazard Backow Prevention device that
meets the requirements outlined in AS/NZS 3500.
Technical information
Power Supply 220-240Vac 50/60Hz
Power Wattage 1700 W
IP Rating IPX4
Note: Any electrical work connected on this project must be installed
by qualied personnel, in accordance with AS/NZS 3000 Wiring Rules.
Certication
Watermark AS1172.1/AS1172.2 Certicate No. WMKA02321
WELS 4 Star, 4.5/3 litre, Average Flush 3.3 litre
RCM

4
Alternative drainage connections
Included
Min. 125
Max. 225 225
180
[mm]
400 435
480
790
385
685 390
65

5
X2
X2
X2
S
M
L
X1
X1 X1
1/2” H - 3/4” H C
X2 X2
X2
X1 X1 X1
X1
X1
1/2” H - 3/8” H A
X2 X2 X2
X1 X1
X1
X1
X1
X2 X2
X2 X1
X1 X1
B
3/8” M - 1/2” H

6
115
Ø1/2”
500 kPa
Option 1a Option 1b
300
115
Ø1/2”
300
Do not use rain water.
Use only potable water.
Electrical
2
Pipes
1
Option 2a Option 2b
55
125
55
125
3 x 1mm2
L = 300 mm
ØMin: 6 mm
ØMax: 8,5 mm

7
220-240Vac
50/60 Hz.
1700 W Max.
D
OFF
25A lDn 0.03A 10 ó 15A
A
According to current legislation
3 x 1mm2
L Min. = 300 mm
ØMin: 6 mm
ØMax: 8,5 mm
Mandatory
C
B
AThe electrical installation must be protected by means of a IDn 0,03A and 25A differential switch and a
magnetothermal switch of 10 or 15A. Both switches must be placed outside the bathroom.
B
A xed power connection must be connected by a dedicated exible power cable consisting of 3 wires (active,
neutral, earth) of at least 1mm2. The connection must be done inside an IPX4 or better junction box. If it is
necessary to replace the power cable, this must be done by qualied service staff.
C220-240Vac 50/60Hz
Note
- Any electrical work conducted on this product must be installed only by qualied personnel, in
accordance with AS/NZS 3000 Wiring Rules.
- Please consult with a qualied electrician to conrm an appropriate installation location.
- No additional electrical equipment should be tted inside the toilet.
- This product (IPX4) shall not be exposed to water jets for cleaning purposes.

8
2
13
Min. 45
1
Ø12
45
90
10
~250
~360
2
13
Min. 45
1
Ø12
45
90
10
~250
~360
2
1

9
Water filter
support
Install the water filter on the most accessible side
a
b
Water filter
support
Install the water filter on the most accessible side
a
b
3
4

10
B
1/2” H - 3/4” H
L = 515
C
3/8” H - 1/2” H
L = 560
A
External connection
3/8” M - 1/2” H
L = 610
B
3/8” M - 1/2” H
1/2” H - 3/4” H C
1/2” H - 3/8” H A
1
2
3
5
6