Jones Qube Adherence Packaging User manual
Qube Adherence Packaging
SEALING INSTRUCTIONS FOR
SYNMED®AUTOMATED FILLING
Place the blisters into the SynMed® tray (1).
When all of the blisters have been placed, insert the tray into the SynMed
machine and follow SynMed’s instructions to operate the machine (2). When
the filling process is complete, remove the tray as instructed to begin the
sealing process. Please note each step below will be repeated across all
eight (8) blisters.
Peel the medication summary label and
affix it to the inside cover of the three-panel card (3a).
en, turn over the card so the front cover is facing up
and fold back the grid panel as shown (3b).
2
1
Remove the liner from the adhesive panel at
a 450 angle (4).
3a 3b
4
t: +1.519.659.8373
tf: +1.800.265.1009
f: +1.519.659.8306
JonesHealthcareGroup.com
3000 Page St. London, ON, Canada N5V 5H3
Before dispensing, the pharmacist should instruct the patient on the proper use of the Qube. To access the contents of
a blister, the patient can turn over the package and puncture the blister backing, then peel back the label and remove
medication. e pharmacist must also advise the patient that the Qube is not child resistant. Keep out of the sight and
reach of children and store in a cool, dry place, away from direct sunlight.
Place the card into a manual Qube sealing tray (8a), and
use a roller to apply firm, consistent pressure across the
surface for a tight final seal (8b).
With the adhesive side facing down, orient the adhesive panel
over the blister in the SynMed tray while keeping the grid panel in
its folded position (5a). Align the cut marks on the grid panel with
the alignment marks on the SynMed tray to ensure the panel is
positioned accurately (5b).
Remove the card from the tray and turn over, so the
medication summary label is facing up (7a). Fold the grid
panel in the opposite direction over the blister using a
bending and pressing motion (7b). Ensure consistent
contact with adhesive across the surface of the panel, so it
lays flat.
5a 5b
6
7a 7b
8b8a
Once the pharmacist has verified the contents for accura-
cy, the Qube is ready to dispense (9).
9
Using your hand, apply pressure to the panel to engage the
adhesive. en use a roller to apply pressure in a vertical and
horizontal motion. Roll multiple times to ensure the card is fully
adhered to
the blister (6).
pharmacy@joneshealthcaregroup.com
Get in Touch With Us:
Table of contents
