
(TunerI
Start the unit by turning on the power switch ON.
Press MODE sev€ral tim6s to switch to Tuner mode, and connect the instrument' s outpul
end with the IMPUT jack. The FUNCTION button, combining with UP/DOWN button, is used
forA4 frequency adrustmsnt or flat selection if needed. You canalso use the build-in MIC to
tune acoustic guilar or other similar instruments.
OA4 Frequency Adiustment
PressFUNCT|ONbuttonseveraltimesuntilthescreenshows "A4=",thenadjusttheA4
frequency with the UP/DOWN button.
OFlat Mode Adiustment
Press FUNCTION button several times until the screen shows 'Flat=" , then Press
UP/DOWN button to choose flat.
*Tuning is basod on lhe dlsplayBd note and iloiEt€r+ s
a slngto-tona, t0ne your instrummt agffiding to the r
a.rrrYrs-rv,rs' Lu,,e rvu,
the pointer goes left and the lsft red led lights, the tons is flat; ifthe pointer goes right and
ihe rioht red led liohts. ihe tone is sharo: il the oointer stavs in the middle and the middls
the right red led lights, ihe tone is sharp; il the pointer stays in the middle and the middls
green led lights, the tone is in tune.
OUse the build-in piano sound as slandard pronunciation
Under tuner mode, SOUND/MUTE would lead you to various notes and standard
pronunciation, press UP/DOWN button to make a selection between those notes.
Your tuning is based on the standard pronunciation of notes.
IMetronome I
Start the unit by turning on the powsr switch ON.
Press MODE several times to switch to Metronomo mode, use FUNCTION and UP/DOWN
buttons to adiust Tempo, Beat, Rhythm, and Tap according to your needs. SOUND/MUTE is
used for switch over sound/mute mode.
aTempo Adjustment
Press FUNCTION button several times until the screen shows "Tempo" , then adjust
ORhythm Adjustment
Press FUNCTION button several times until the screen ihows "Rhythm" , then adjust
rhythm with the UP/DOWN button.
aFunction ofTap
Press FUNCTION button several times uniil the screen shows "Tap" ; then press UP
button to start the Tap function. You nsod to press the UP button again to choose speed
value- the beats per minute, which depends on the last two pressing. The screen shows
208 and 40 even though lhe actual speed value is higher or lower than lhese numbers.
You hav-e to restart the Tap function if you fail to press the UP again within 2 seconds.
(RhythmPlayI
Start the unit by turning on the power switch ON.
Press MODE several times to switch to RhythmPlay mode, use FUNCTION and UP/DOWN
buttons to adjust RhythmPattern and Tempo according to your needs. SOUND/MUTE is used
for switch wer sound/mute mode.
aRhythmPattern Adjustment
Press FUNCTION button several times until the screen shows "RhythmPattern" , then
adjust rhythm pattdrn with the UP/DOWN button.
aTempo Adjustment
Press FUNCTIoN button several times until the screen shows 'Tempo" , then adjust
tempo with the UP/DOWN button.