Page 9
Depending on the position of the letters on the wooden legs A B, first place the
small footplate in the top position. Then tighten the screws one by one. The small
footplate must be placed above, the large one below (Fig B6)
Step 4: Connect the seat to the turntable
(please use the screw size M8 x 16)
Take the seat and the turntable and align the 4 holes of the seat with the 4 holes of
the turntable. Secure with small A15 screws. Use the inner hexagonal tool to secure
them. The seat and the turntable must be tightly connected so that the turntable
button can be used easily. (Fig. B7
Step 5: Connect the turntable to the wooden feet
(please use the screw size M8 x 45)
The front of the seat and the footplates must be aligned. The 4 holes of the
turntable must be aligned with the 4 holes of the wooden support. Use the A10
screws and tightened them with the big inner hexagonal tool. Then fix the A11
screw in the middle hole and tighten it with the small inner hexagonal tool. When
fixing the screws, the seat must be positioned with the legs up. The screws must be
tightened very well otherwise the stability of the seat will be affected. (Fig. B8)
Note: Permanently check the screws to be very well tighten so the stability of the
seat not be affected.
Step 6: Install the crotch on the tray
While holding the crotch, push it into the slot on the back of the tray. It is
correctly installed when a "click" sound is heard. (B9)
Step 7: Install the tray
While holding the adjustment button, which is under the tray, with one hand as in
Fig. B10, align the 2 rails with the arms of the seat and then push the tray forward
until it reaches the correct position. It is fixed when a "click" sound is heard. The
tray is double, so the top can be removed and can be easily cleaned.
After the complete installation of the product, install A13 non-slip pillows so that
the table seat does not slip and does not damage the floor. (Fig. 11))
