Shenzhen Just Motion Control Electro-mechanics Co., Ltd 0755-26509689
1. Overview............................................................................................ - 4 -
2. Features..............................................................................................- 4 -
3. Ports Introduction.............................................................................- 5 -
3.1 ALM signal output ports......................................................... - 5 -
3.2 Control Signal Input Ports....................................................... - 5 -
3.3 Power Interface Ports............................................................ - 15 -
4. Technological Index..........................................................................- 7 -
5. Connections to Control Signal.........................................................- 8 -
5.1 Connections to Common Anode............................................. - 8 -
5.2 Connections to Common Cathode...........................................- 9 -
5.3 Connections to Differential Signal.......................................... - 9 -
5.4 Connections to 232 Serial Communication Interface........... - 10 -
5.5 Sequence Chart of Control Signals....................................... - 11 -
6. DIP Switch Setting..........................................................................- 12 -
6.1 Micro steps Setting................................................................ - 12 -
6.2 Activate Edge Setting............................................................ - 13 -
6.3 Running Direction Setting.....................................................- 12 -
7. Faults alarm and LED flicker frequency..................................... - 14 -
8. Appearance and Installation Dimensions.....................................- 15 -
10. Parameter Setting......................................................................... - 16 -
11. Processing Methods to Common Problems and Faults............ - 20 -
11.1 Power on power light off.....................................................- 20 -
11.2 Power on red alarm light on................................................ - 21 -
11.3 Red alarm light on after the motor running a small angle.. - 21 -
11.4 After input pulse signal but the motor not running.............- 21 -
