JVC KD-S656R User manual

CD RECEIVER
CD-RECEIVER
RECEPTEUR CD
CD-RECEIVER
BEDIENUNGSANLEITUNG
MANUEL D'INSTRUCTIONS
GEBRUIKSAANWIJZING
INSTRUCTIONS
LVT0148-001A
[E]
Detachable
MNMMDWJEIN
KD-S656R/S653R
For installation and connections, refer to the separate manual.
Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch.
Pour l’installation et les raccordements, se référer au manuel séparé.
Bijzonderheden over de installatie en aansluiting van het apparaat vindt u in de
desbetreffende handleiding.
NEDERLANDS DEUTSCH
FRANÇAIS ENGLISH
SOUND
TP/ RDS
MO
RND
DISP
PTY RPT
KS-S653R
5
CD
FM
AM
789
10 11 12
¢
4
/ATT
3 5 W x 4
SSM
SEL
0
SOUND
TP/ RDS
MO
RND
DISP
PTY RPT
KS-S656R
5
CD
FM
AM
789
10 11 12
¢
4
/ATT
3 5 W x 4
SSM
SEL
0
KD-S656R
KD-S653R

2
BEFORE USE
* For safety....
• Do not raise the volume level too much, as this
will block outside sounds, making driving
dangerous.
• Stop the car before performing any complicated
operations.
*Temperature inside the car....
If you have parked the car for a long time in hot
or cold weather, wait until the temperature in the
car becomes normal before operating the unit.
IMPORTANT FOR LASER
PRODUCTS
Precautions:
1. CLASS 1 LASER PRODUCT
2. DANGER: Invisible laser radiation when
openandinterlockfailed or defeated.Avoid
direct exposure to beam.
3. CAUTION: Do not open the top cover.
Therearenouser-serviceablepartsinside.
Leave all servicing to qualified service
personnel.
4. CAUTION: This CD player uses invisible
laser radiation and is equipped with safety
switches to prevent radiation emission
when unloading CDs. It is dangerous to
defeat the safety switches.
5. CAUTION:Useofcontrols,adjustmentsor
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
Position And Reproduction Of Labels
Note:
For security reasons, a numbered ID card is provided with this unit, and the same ID number is
imprinted on the unit’s chassis. Keep the card in a safe place, as it will help the authorities to
identify your unit if stolen.
DANGER: Invisible laser
radiation whenopen and
interlock failedordefeated.
AVOID DIRECT EXPOSURE
TO BEAM. (e)
ADVARSEL:Usynlig laser-
stråling ved åbning, når
sikkerhedsafbrydere erude
af funktion. Undgåudsæt-
telse for stråling. (d)
VARNING:Osynliglaser-
strålning när denna del
är öppnadochspärren är
urkopplad. Betrakta ej
strålen. (s)
VARO : Avattaessa ja suo-
jalukitus ohitettaessa olet
alttiina näkymättömälle
lasersäteilylle. Älä katso
säteeseen. (f)
Caution:
This product contains a laser component
of higher laser class than Class 1.
Bottom panel of the main unit
Name/Rating plate
EN 02-04.KD-S656R/653R 98.10.29, 4:19 PM2

3
ENGLISH
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to
ensure your complete understanding and to obtain the best possible performance from the unit.
CONTENTS
BASIC OPERATIONS .................................................... 4
RADIO OPERATIONS ................................................... 5
Listening to the radio .....................................................................5
Storing stations in memory ............................................................6
FM station automatic preset:SSM ................................................6
Manual preset.............................................................................. 7
Tuning into a preset station ........................................................... 8
When an FM stereo broadcast is hard to receive ........................8
RDS OPERATIONS ....................................................... 9
What you can do with RDS EON ..................................................9
Tracing the same programme automatically
(Network-Tracking Reception).................................................9
Using Standby Reception .......................................................... 11
SelectingYour Favorite Programme for
PTY Standby Reception............................................................ 12
SearchingYour Favorite Programme..........................................12
Other convenient RDS functions................................................. 15
Automatic selection of the station
when using the number buttons ............................................15
Changing the display mode while listening to an FM station..... 15
Setting the TA volume level ........................................................15
Automatic clock adjustment...................................................... 16
CD OPERATIONS....................................................... 17
Playing a CD ................................................................................. 17
Locating a track or a particular portion on a CD ..................... 18
Selecting CD playback modes......................................................19
Prohibiting CD ejection ............................................................... 19
SOUND ADJUSTMENTS ............................................. 20
Selecting preset sound modes ......................................................20
Adjusting the sound...................................................................... 21
Storing your own sound adjustments ......................................... 22
OTHER MAIN FUNCTIONS .........................................23
Setting the clock ............................................................................23
Changing the general settings......................................................25
Detaching the control panel ......................................................... 26
MAINTENANCE ......................................................... 27
Handling CDs ................................................................................ 27
TROUBLESHOOTING .................................................28
SPECIFICATIONS .......................................................29
EN 02-04.KD-S656R/653R 98.10.29, 4:19 PM3

4
BASIC OPERATIONS
1
Turn on the power.
2
Select the source.
To operate the tuner, see pages 5 – 16.
To operate the CD player, see pages 17 – 19.
3
Adjust the volume.
4
Adjust the sound as you want (see pages 20 – 22).
To drop the volume in a moment
Press briefly while listening to any source. “ATT” starts flashing on the display,
and the volume level will drop in a moment.
To resume the previous volume level, press the button briefly again.
To turn off the power
Press and hold for more than 1 second.
Note on One-Touch Operation:
When you select a source in step 2 below, the power automatically comes on. You do not have to
press this button to turn on the power.
F MA M C D
Volume level appears.
1
23
Note:
When you use this unit for the
first time, set the built-in
clock correctly, see page 23.
Volume level indicator
EN 02-04.KD-S656R/653R 98.10.29, 4:19 PM4

5
ENGLISH
RADIO OPERATIONS
Listening to the radio
1
Select the band (FM1, FM2, FM3
or AM).
YoucanselectanyoneofFM1, FM2, andFM3
to listen to an FM station.
1
2
F MA M
FM1
AM FM2
FM3
2
Start searching a station.
When a station is received, searching stops.
To stop searching before a station is received, press the same button you have pressed
for searching.
To tune in a particular frequency without searching:
1Select the band (FM or AM).
Press FM or AM.
2 Press and hold ¢or 4until “M” starts flashing on the display.
Now you can manually change the frequency while “M” is flashing.
3 Press ¢or 4repeatedly until the frequency you want is reached.
• Ifyou hold down thebutton,the frequency keeps changing(in50 kHz intervals forFMand
9kHz intervals for AM-MW/LW) until you release the button.
SSM
To search stations
of higher
frequencies.
To search stations
of lower
frequencies.
EN 05-08.KD-S656R/653R 98.10.29, 4:20 PM5

6
Storing stations in memory
You can use one of the following two methods to store broadcasting stations in memory.
• Automatic preset of FM stations:SSM (Strong-station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset:SSM
You can preset 6 local FM stations in each FM band (FM1, FM2, and FM3).
12
F M
1
Select the FM band number (FM1, FM2 or
FM3) you want to store FM stations into.
2
Press and hold both buttons for more than 2
seconds.
Local FM stations with the strongest signals are searched and stored automatically in the
band number you have selected (FM1, FM2 or FM3).These stations are preset in the number
buttons — No. 1 (lowest frequency) to No. 6 (highest frequency).
When automatic preset is over, the station stored in number button 1 will be automatically
tuned in.
SSM
“SSM” appears, then disappears when
automatic preset is over.
FM1 FM2 FM3
EN 05-08.KD-S656R/653R 98.10.29, 4:20 PM6

7
ENGLISH
Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually.
EXAMPLE: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band
12 3
1
Select the FM1 band.
2
Tune into a station of 88.3 MHz.
See page 5 to tune into a station.
3
Press and hold the button for more than 2
seconds.
4
Repeat the above procedure to store other stations into other
preset numbers.
Notes:
• A previously preset station is erased when a new station is stored in the same preset number.
• Preset stations are erased when the power supply to the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset the stations again.
F M
SSM
12
“P1” flashes for a few seconds.
EN 05-08.KD-S656R/653R 98.10.29, 4:20 PM7

8
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you have not stored them yet, see pages 6
and 7.
1
Select the band (FM1, FM2, FM3
or AM) you want.
2
Select the number (1 – 6) for the
preset station you want.
F MA M
FM1
AM FM2
FM3
12
123456
MO/RND
When an FM stereo broadcast is hard to receive
Press MO/RND (Mono/Random) while listening to an FM stereo broadcast.
The “MO” (Mono) indicator lights up on the display.The sound you hear becomes monaural
but reception will be improved.
To restore the stereo effect, press the same button again.
Lights up when receiving an FM broadcast in stereo.
EN 05-08.KD-S656R/653R 98.10.29, 4:20 PM8

9
ENGLISH
What you can do with RDS EON
RDS OPERATIONS
RDS (Radio Data System) allows FM stations to send an additional signal along with their
regular programme signals. For example, the stations send their station names, as well as
information about what type of programme they broadcast, such as sports or music, etc.
Another advantage of RDS function is called “EON (Enhanced Other Networks).” The EON
indicator lights up while receiving an FM station with the EON data. By using the EON data
sent from a station, you can tune into a different station of a different network broadcasting
your favorite programme or traffic announcement while listening to another programme or to
another source such as CD.
By receiving the RDS signals, this unit can do the following:
• Tracing the same programme automatically (Network-Tracking Reception)
• Standby Reception of TA (Traffic Announcement) or your favorite programme
• PTY (Programme Type) search
• TA (Traffic Announcement) search
• And some other functions
Tracing the same programme automatically (Network-
Tracking Reception)
Whendriving inanareawhereFM reception is not good,thetunerbuiltinthisunit automatically
tunes in another RDS station, broadcasting the same programme with stronger signals. So,
you can continue to listen to the same programme in its finest reception, no matter where you
drive. (See the illustration on the next page.)
Two types of the RDS signals are used to make Network-Tracking Reception work correctly
— PI (Programme Identification) and AF (Alternative Frequency) data.
Without receiving these data correctly from the RDS station you are listening to, Network-
Tracking Reception will not operate.
To use Network-Tracking Reception, Press and hold TP/RDS (Traffic
Programme/Radio Data System) for more than 1 second. Each time you
press and hold the button, Network-Tracking Reception modes change as
follows:
TP/RDS
Mode 1 Mode 2 Mode 3
EN 09-16.KD-S656R/653R 98.10.29, 4:20 PM9

10
Mode 1 (AF: on / REG: off)
Network-Tracking is activated with Regionalization set to “off.”
Switches to another station within the same network when the receiving
signals from the current station become weak.
Note:
In this mode, the programme may differ from the one currently received.
Mode 2 (AF: on / REG: on)
Network-Tracking is activated with Regionalization set to “on.”
Switchestoanotherstation, within the same network, broadcasting the same
programmewhen thereceivingsignalsfromthecurrent station become weak.
Mode 3 (AF: off / REG: off)
Network-Tracking is deactivated.
The same programme can be received on different frequencies.
Programme 1 broadcasting on
frequency B
Programme 1 broadcasting
on frequency A
Programme 1 broadcasting on frequency D
Programme 1 broadcasting on frequency C
Programme 1 broadcasting on frequency E
EN 09-16.KD-S656R/653R 98.10.29, 4:20 PM10