08
PIN CODE
DIFFERENT PIN CODE
After powering up the remote if no
controllers with matching pins codes
are found within the signal range the
stored remote pin code will be displayed.
SAME PIN CODE
After powering up the remote, if a
controller(s) with matching pins code
is found within the signal range the
remote will display the first station
number with a run time.
NOTE: Only stations with a programmed
run time in the controller will be displayed
and operational from the remote.
CHANGING THE PIN CODE ON THE REMOTE
The Pin Code default setting (out of the box)
is factory set at 1111 but can be changed to
any combination between 0001 – 9999.
This allows a single remote the ability
to operate many controllers by simply
matching the controllers pin code.
To change the Pin Code:
• Power up the remote
OR
• Press the LEFT and RIGHT arrow
buttons simultaneously and hold
for two seconds. The pin code will
begin to flash.
1.Press the UP arrow button to
increase the flashing number value
and the DOWN arrow button to
decrease the flashing number value.
2.Press the RIGHT arrow button to advance to
the next pin number or the LEFT arrow button.
3. Once the desired pin code has been entered,
press the ON/OFF SELECT button.
Owner’s Manual and Installation Instructions
