Kärcher KM 130/300 R D User manual

QUICKSTART
5.964-137.0 03/12
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers
for the operator and other persons.
Start up
1A
C
B
D
A Tilt the driver's seat forward and secure it.
Opening and securing hood.
B Check oil level.
C Check cooler water level.
D Close cover.
2A B A Check roller brush.
B Check side brush.
3ABCA Sit on the driver's seat.
B Turn the ignition key to position "I".
C Check fuel level via the tank indicator.
Fill in diesel.
4ABCA Pull seat adjustment lever outwards.
B Slide seat, release lever and lock in place.
Check that the seat is properly locked in
position by attempting to move it backwards
and forwards.
C Adjust the seat back.
KM 130/300 R D

QUICKSTART
5.964-137.0 03/12
Operation
1A
D
B
E
C
F
Starting the machine
A Sit on the driver's seat.
Do NOT press the accelerator pedal.
B Lock parking brake.
C Bring the direction selector switch into
the middle position.
D Engine speed adjustment - push forward by
1/3.
E Insert the ignition key into the ignition lock.
Turn the ignition key to position "Filament".
Pre-heat lamp glows.
F When the pre-heating lamp goes off, turn the
ignition key to position "II".
If the machine starts, release the ignition key.
Release parking brake.
2A
D
G
B
E
H
C
F
I
Drive the machine
Caution
Risk of damage. Only use the direction switch
when the machine is standing still.
A Set programme switch to step 1 (driving).
B Move the gas lever all the way to the front
(high speed).
C Press brake pedal and keep it depressed.
D Release parking brake.
Drive forward
E Set the travel direction switch to "forward".
F Press accelerator pedal down slowly.
Reverse drive
Danger
Risk of injury! While reversing, ensure that
there is nobody in the way, ask them to move if
somebody is around.
G Set the travel direction switch to "backwards".
H Press accelerator pedal down slowly.
Brakes
I Release the accelerator pedal, the machine
brakes automatically and stops.
Note
The braking effect can be supported by pressing
the brake pedal.
3A B Sweeping mode
Sweeping with sweep roller
A Set programme switch to step 2. Roller brush
is lowered.
Sweeping using roller brush and side brushes
B Set programme switch to step 3. Side brush-
es and roller brush are lowered.
4ASweeping damp or wet floors
A Switch off the blower.

QUICKSTART
5.964-137.0 03/12
5ACleaning the dust filter
A Press the switch of the dust filter cleaning
system.
6AOperation with beacon lamp
A Switch on the beacon lamp.
7A
CD
BEmptying waste container
Danger
Risk of injury! When emptying the waste
container, care should be taken to ensure that no
persons or animals are within its swivelling range.
Danger
Danger of crushing. Never reach into the rod
assembly for the drainage mechanism. Stay
away from the area under the raised container.
Danger
Danger of tipping. Place the machine on an even
surface during emptying.
A Raise waste container.
Slowly drive towards the collection container.
Lock parking brake.
B Open the flap of the waste container.
C Close the flap of the waste container.
Release parking brake.
Drive away the collection container slowly.
D Lower the waste container up to the
end-position.
Finish operation
1Emptying waste container
See "Operation", item 7.
2ABCTurn off the appliance
A Set programme selection to "Drive".
Push the motor speed adjustment all the way
to the rear.
B Press brake pedal and keep it depressed.
Lock parking brake.
C Turn ignition key to "0" and remove it.
Operation

QUICKSTART
5.964-137.0 03/12
Maintenance and care
daily weekly Kärcher Customer Service
1AA Check fuel filter.
2AA Check the centrifugal separator
and the air filter, clean if required.
3A Check function of all operator
control elements.
B Check appliance for damages.
4A B A Check the hydraulic oil level.
B Check brake fluid status.
Danger
Risk of injury! Always apply the safety
bar when the waste container is raised.
5A B A Check dust filter and clean filter
box, if required.
B Clean the machine with a damp
cloth which has been soaked in
mild detergent.
Note
Do not use aggressive cleaning
agents.
6A Clean the water cooler.
B Clean the hydraulic oil cooler.
C Check hydraulic unit.
D Check the pad for wear, replace if
required.
E Check the container lid and lubri-
cate it.
7See inspection checklist
5.950-646.0!

QUICKSTART
5.964-137.0 03/12
Troubleshooting
1A
D
B
E
C Appliance cannot be started
A Sit on the driver seat, the seat contact
switch gets activated.
B Bring the direction selector switch into
the middle position.
C Charging or replacing battery
D Fill in fuel, deaerate the fuel system
E Change fuel filter
2A Engine is running erratically
A Remove the air filter housing.
Clean air filter or change filter cartridge.
3A B C Engine is running but machine is not moving
A Set the travel direction switch to "forward" or
"reverse".
B Release parking brake
C Check the free-wheeling of the hydraulic
pump
4A
D
B
E
C Sweeping unit does not pick up waste
A Empty waste container
See "Operation", item 7.
B Check dust filter, clean or replace
C Replacing roller brush
Remove the blocking of the brush roller
D Adjust sweeping track
E Replace the side brushes
5A B Dust gathers in the machine
A Check dust filter, clean or replace
B Switch on the blower.