KAMA-LABS YULIA v6 User manual

1
www.Kama-Labs.com
ASSEMBLY MANUAL
FOR
YULIA v6
IV-11/IV-12 VFD CLOCK
If you will have any questions, contact
with me here:
[e-mail]
GOOD LUCK!
^_^

2
1) You have a PCB with ICs. MCU preprogrammed already:
2) Place all resistors vertical:

3
3) Place res.arrays. Common pin to square pad
4) Place diodes according marking on PCB:

4
5) Place all electrolytic capacitors. Be careful with polarity!

5
6) Place ceramic capacitor. Polarity is not matter.

6
7) Place all transistors and IC5 according marking on PCB:

7
8) Place temperature sensor IC7 on bottom side of PCB:

8
9)Place inductor:

9
10) Place photoresistor.

10
11) Install buzzer:

11
12) Place battery holder and insert battery when clock will be fully
assembled:
13) Place sockets for IC. Insert MC34063 chip at the end of
assembling process:

12
14) Install Infrared receiver:
15) Install leds to the bottom side of PCB:

13
16) Install socket for power supply:

14
17) After all, your board should looks like on photo:

15

16
18) Prepare and install all IV-11 tubes. You can see that pins of
tubes cuts spiral already. The longest pin –the first pin:

17

18

19
19) How to install IV-12 tubes:

20