La Crosse Technology 404-50447 User manual

Page | 1Page | 4
WARRANTY INFO
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from
date of purchase) on this product relating to manufacturing defects in
materials & workmanship.
La Crosse Technology, Ltd, 2830 S. 26th St., La Crosse, WI 54601
For Full Warranty Details, Visit:
www.lacrossetechnology.com/support
CARE + MAINTENANCE
Battery replacement instruction:
When batteries of dierent brand or type are used together, or new and
old batteries are used together, some batteries may be over-discharged
due to a dierence of voltage or capacity. This can result in venting,
leakage, and rupture and may cause personal injury.
• Always purchase the correct size and grade of battery suitable for the
intended use.
• Always replace the whole set of batteries at one time, taking care not
to mix old and new ones, or batteries of dierent types.
• Clean the battery contacts and those of the device prior to battery
installation.
• Ensure the batteries are installed correctly with regard to polarity
(+ and -).
• Remove batteries from product during periods of non-use. Battery
leakage can cause corrosion and damage to this product.
• Remove used batteries promptly.
• For recycling and disposal of batteries, and to protect the environment
please check the internet or your local phone directory for local
recycling centers and / or follow local government regulations.
CA WARNING:
This product can expose you to chemicals including acrylonitrile,
butadiene, and styrene, which are known to the State of California to
cause cancer and birth defects or other reproductive harm.
For more information, go to: www.P65Warnings.ca.gov
12.8 INCH
ATOMIC WALL CLOCK
Model: 404-50447
DC: 051922

6
5
SET
RESET
WAVE (Atomic search)
Battery
Time Zone Selector
Daylight Saving Time
Selector
4
3
2
1
6
5
4
3
2
1
Page | 3Page | 2
POWER UP
Set Time:
1. Hold SET for 3 seconds to manually set your time.
• Press and hold SET again to move hands quickly.
• Press and release SET to move hands forward step by step.
Note: The Atomic Time Signal will override your manual setting if
the transmission is received in the future.
MANUAL SET TIME
1. Select Time Zone and DST settings.
2. Insert 1 AA battery into the Battery Compartment.
3. The hands will move to the 12 o’clock position and search for
the WWVB Atomic Time Signal for up to 8 minutes.
• If no signal, after 8-10 minutes, clock will run from 12:00.
• Clock will continue to search for the WWVB Atomic Time
Signal. Allow up to 5 nights for the clock to receive this
transmission.
4. For the best reception, place the clock on an exterior wall near
a window with the front or back of it facing Fort Collins, CO.
Watch the setup video: bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive the
WWVB reception due to signal strength or interference. In this
case, your clock can be set manually until the Atomic Time Signal
can be received.
For information about WWVB, Atomic Time Signal visit: bit.ly/AtomicTime Ask questions, watch detailed setup videos, and provide
feedback on our social media outlets!
LET’S BE SOCIAL!
• If the clock does not respond when trying to manually set your
time, press the RESET button one time.
• The hands will move to the 12 o’clock position and begin
searching for the WWVB Signal again.
RESET BUTTON
Battery Requirements: 1 AA (IEC LR6) required in movement
Battery not included.
Battery Life: 12 months
Dimensions: 12.8” Diameter x 1.77” Deep
SPECIFICATIONS